SRC K-VS1000-02-01-SL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: K-VS1000-02-01-SL / K-VS1000-02-02
Part Description: Radiator Guard –Kawasaki Versys1000 (2015 –2018)
Installation / Parts List / Bill of Material for Mounting
The Scope of supply from SRC will be the Metal Guard (Radiator Guard) and M8 Washer –2
off

Copyright By SRC
Design and Specification are subjected to change
Page 2
MOUNTING DRAWINGS

Copyright By SRC
Design and Specification are subjected to change
Page 3
Step 1:
Remove the 2 off Hexagonal Head Bolts,
as shown in the drawing, one on top side
and other one on the bottom side, from
its mounting point, and keep them aside.
The same Hexagonal Head Bolts will be
required to mount the Radiator Guard,
which will be explained in subsequent
steps.
Mounting Instructions
Step 2:
Orient and Align the Radiator Guard, as
shown, and Slip-in the M8 Washer –2 off,
and 2 –off Hexagonal Head Nut and
through the mounting holes in the flap of
the Radiator Guard, in-line with the
mounting points (shown in red color).
Step 3:
Secure the threads in the mounting point
Ensure Orientation symmetry of the Radiator
Guard and visually check for no fouling points
below its surface or on the sides and tighten
it fully as per OE Torque specifications ( 22 –
24 N-m)

Copyright By SRC
Design and Specification are subjected to change
Page 4
General Instructions
1. We request you to pay attention to the Mounting Instructions in this document and follow
the step-by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the
Accessory part to the Vehicle. We have prepared this based on our experience and knowledge,
related to the Vehicle, Part and its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s
accessory part. It is advised to the User, to inspect and ensure the original state of all other
Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving behaviour
and/or the stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it will
help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and Check all
functions of the Vehicle. It is always advised to check loosening of the fasteners after the first
50 kilo meters of ride and at regular intervals.
7. We are showing here the Scope of Supply/ Installation/Parts list & BOM from SRC
8.To the maximum extent possible, our design use the current Mounting/Fitment of the
Original Equipment, so that Installation of these accessories will not affect the Payload or
Function of the Vehicle or the Part on which it is mounted to protect it
9.If any additional modifications are to be done, prior to the fitment of the accessories, it
will be explicitly specified in the instruction sheets.