SRC BMW-R1200GS-04-01-AL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
NO. Description Quantity Torque * (N-M) Remarks **
4
4
1
4
1
2
3
4
Top Rack
Bush
Washer M6
SRCDesign uses MetricSystem of Measurement and all dimensions in Millimeters
*Recommended to use the Torque specified in the table
**Denotes Usage of Liquid Thread Locker in specified Locations
Screw M6 X 30
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: BMW-R1200GS-04-01-AL / BMW-R1200GS-04-02-AL
Part Description: Top Rack –BMW R1200 GS
Installation / Parts List / Bill of Material for Mounting

Copyright By SRC
Design and Specification are subjected to change
Page 2
MOUNTING DRAWINGS

Copyright By SRC
Design and Specification are subjected to change
Page 3
Step 1:
The OEM Accessory where the Top
Rack is to be fitted, is as shown in
the drawing above
Step 2:
Orient and Align the Top Rack (1),
Washer M6 –4 off (4), Screw M6 x 30
–4 off (3), and place the Bush –4 off
(4), as shown in the drawing, in-line
with the Mounting hole in the
Motorbike
The Bush is to be sandwiched
between the Top surface of the
Mounting Hole and the bottom side
of the Top Rack.
The final mounted condition of the
Top Rack is as shown in the drawing
on the right.

Copyright By SRC
Design and Specification are subjected to change
Page 4
General Instructions
1. We request you to pay attention to the Mounting Instructions in this document and
follow the step-by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the
Accessory part to the Vehicle. We have prepared this based on our experience and
knowledge, related to the Vehicle, Part and its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s
accessory part. It is advised to the User, to inspect and ensure the original state of all
other Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving
behaviour and/or the stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it
will help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and Check all
functions of the Vehicle. It is always advised to check loosening of the fasteners after
the first 50 kilo meters of ride and at regular intervals.
7. We are showing here the Scope of Supply/ Installation/Parts list & BOM from SRC
8. To the maximum extent possible, our design use the current Mounting/Fitment of the
Original Equipment, so that Installation of these accessories will not affect the Payload
or Function of the Vehicle or the Part on which it is mounted to protect it
9. If any additional modifications are to be done, prior to the fitment of the accessories, it
will be explicitly specified in the instruction sheets.