SRC Y-T700-20-01-SL Guide

Copyright By SRC
Design and Specification are subjected to change
Page 1
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: Y-T700-20-01-SL / Y-T700-20-02
Part Description: FRAME PROTECTORS –YAMAHA Tenere700

Copyright By SRC
Design and Specification are subjected to change
Page 2
MOUNTING DRAWINGS

Copyright By SRC
Design and Specification are subjected to change
Page 3
Mounting Instructions
SRC Frame Protector uses the mounting hole
located (as shown in the drawing). The
Protector shields the frames (Left side)
Step 1:
Before starting to mount, we have Remove
the Original Screw in Motobike (as shown in
the drawing).
Step 2:
Orient the Bottom end of the Frame
Protector, in-line with the Mounting Hole
and secure it using the Mounting Bolt
(already available in the Motorbike

Copyright By SRC
Design and Specification are subjected to change
Page 4
Step 3:
Ensure visually the Protector shields the
Frame, as shown and tie-up the cable to the
frame at the top and tighten the bolt.

Copyright By SRC
Design and Specification are subjected to change
Page 5
General Information
1. We request you to pay attention to the Mounting Instructions in this document and follow the step-
by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the Accessory part to the
Vehicle. We have prepared this based on our experience and knowledge, related to the Vehicle, Part and
its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s accessory part. It
is advised to the User, to inspect and ensure the original state of all other Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving behaviour and/or the
stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it will help.
6. To the maximum extent possible, our design use the current Mounting/Fitment of the Original
Equipment, so that Installation of these accessories will not affect the Payload or Function of the Vehicle or
the Part on which it is mounted to protect it
7. If any additional modifications are to be done, prior to the fitment of the accessories, it will be explicitly
specified in the instruction sheets.