Steelcase c:scape User manual

Page 1 of 4
939500370 Rev D
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2009 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
c:scape™Low Storage Counterweight Packages
Topic Page
Table of Contents
Removing a Drawer 2
Installing Counterweight Packages 3
Re-Installing the Drawer 4
Style No.Case Width
30" CQLC1
36" CQLC2
42" CQLC2
48"
Counterweight
Packages
3
4
4
3 CQLC1
#2 SQUARE
OR QUADREX
#2 SQUARE
OR QUADREX
DRIVE BIT

1
3
2a
2b
Page 2 of 4
939500370 Rev D
Removing a Drawer
1. Remove #8-18 x 1/4" screws
connecting drawer body to
suspensions.
2. Toward the rear of the
drawer, use a flat-blade
screwdriver to disengage
the drawer body barbs from
the suspensions.
3. Lift drawer out of suspensions.
#8-18 X 1/4" SCREW

Page 3 of 4
939500370 Rev D
BACK
BRACE
BASE
1b
2
1a
COUNTERWEIGHT
PACKAGE
#10-32 X 1/2" SCREW
COUNTER-
WEIGHT
BACK
BRACE
BASE
Installing
Counterweight
Packages
NOTE: File drawer must
be removed prior to adding
counterweight.
1. Insert the counterweight
packages against the back
brace at the rear of case.
Reminder: Install all
required counterweight
packages.
For 30" and 48" wide units:
Three (3) counterweight
packages (CQLC1).
For 36" and 42" wide units:
Four (4) counterweight
packages (CQLC2).
2. Line up holes in
counterweight package with
the holes in back brace,
starting at one side and
working across. Install
one (1) #10-32 x 1/2" screw
into each hole. Driving
torque not to exceed 40 in-lbs.
PACKAGE
COUNTER-
WEIGHT
PACKAGE
NOTE: If counterweight package
gets separated, make sure the
two large flat plates are nested
when reassembling the package.
OR
OR
NOT

Page 4 of 4
939500370 Rev D
1b
2b
DRAWER
LOOP
LOOP
TAB
2a
LOOP
TAB
Re-Installing the
Drawer
1. Fully extend the
suspensions (1a), then
lower the drawer toward
suspensions (1b).
2. Line up each tab on
drawer with each loop on
suspension (2a). Push
tabs into each loop.
Secure drawer by inserting
one (1) #8-18 x 1/4" screw
into each front loop on
suspension (2b).
3. If the case has two (2)
drawers, check that the
interlock is functioning
properly (Reference
assembly direction
939500368).
#8-18 x 1/4" SCREW
DRAWER
1a
1a