Steelcase FrameOne User manual

Page 1 of 3
FRAMEONE
Assembly Instruction - Side Screen
®
July 2009
Side Screen + Table
1. Remove both of the Side Screen’s bottom caps.
2. Slide the Screen Brackets into the side slot of the Side
Screen as shown. Do the same to the opposite
bracket.
2
Side
Screen
1

Page 2 of 3
FRAMEONE
Assembly Instruction - Side Screen
®
July 2009
Side Screen + Table
3. Align the Set Screw to the desired Screen height
guide hole. Tighten this screw to lock it to the guide hole.
Align the other bracket to the same height and repeat this step.
4. Re-install both bottom caps of the Screen.
3
4
Set Screw
Screen Height
Guide Hole
Screen Height Guide Hole
This hole functions as a guide to
determine the overall height of the
screen/panel installed to the FrameOne desk.
Note:
Lowest Guide Hole = Highest Screen Position

Page 3 of 3
FRAMEONE
Assembly Instruction - Side Screen
®
July 2009
7
5
6
Hook Plate
Side Screen + Table
5. Align the Side Screen to the table.
Make sure that the Side Screen is flush the
table edging.
6. Tighten two M4 screws to the Screen Bracket through
the hook plate.
7. Shown is a completed installation of the opposite Screen Bracket.