Steelcase Pedestal 9000 Series User manual

Page 1 of 5
939503250 Rev D
Series 9000®Pedestal
®
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2001 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
3/8" HEX
SOCKET
#2 PHILLIPS BIT
NOTE: For pedestals manufactured
prior to February 2004, install per
assembly direction 939501118.
Components
#10 x 1/2" SELF
DRILLING SCREW
(GQTFC)
1/4-14 x 1" WOOD
TAPPING SCREW
(853015040MP)
HANGER BRACKET
(1043853SR)

Page 2 of 5
939503250 Rev D
3
4
Removal of Drawers
1. Pull drawer forward.
2. Push on tab on each side of the
drawer rails.
3. Remove drawer completely.
4. Push drawer rails back into
pedestal.
5. Remove remaining drawers.

TIP: Mark all drawers so they can be
easily re-installed in their original
positions.
1
2

Page 3 of 5
939503250 Rev D
Hanger Bracket
Installation

(Pedestals are shipped with
brackets already installed)
1. With drawers removed,
insert hanger bracket into top of
pedestal (1a) and rotate into
place (1b).
2. Pivot the hanger bracket
until it is flat with the top of the
pedestal and slide towards the
rear of the pedestal until it
stops.
3. Ensure that the hanging
tabs are above the pedestal
rear brace, and that the bracket
front tabs are resting on the
pedestal side flanges. Attach
the hanger bracket using two
(2) #10 x 1/2" self-drilling
screws (GQTFC).
TIP: Remove the hanger
bracket prior to mounting a
22-5/8" pedestal beneath a 30"
worksurface, using adapter
brackets. See assembly
direction 939503251 for details.
1a
3
2
1b
#10 X 1/2" SELF-DRILLING
SCREWS (GQTFC)
HANGING
TAB
HANGER
BRACKET
BRACKET
FRONT TAB

Page 4 of 5
939503250 Rev D
Pedestal Installation
1. Insert pedestal hanging tabs into
worksurface rear brace slots.
2. Secure the pedestal to the
worksurface with three (3) 1/4-14 x 1"
wood tapping screws (853015040MP).
3. Adjust end panel glides to level the
worksurface.
1 2a
2b
2c
2 SCREWS 2 SCREWS1 SCREW 1 SCREW

Page 5 of 5
939503250 Rev D
Drawer Re-Assembly

NOTE: Remember to re-install drawers in their
original positions.

1. Verify that drawer rails are pushed back into
pedestal.

2. Pull ball cages on drawer rails to front of
drawer rails.

3. Carefully align drawer portion of rail with ball
cage of pedestal portion of rail and gently push
drawer back into pedestal.

TIP: Failure to re-assemble drawers correctly
may damage rails, rendering them non-functional.
3
1
2