Sundstrom SR 200 User manual

Drawn up by:
2010-09-13 / RK
HI-SR 200 USA
Revision:
02
Reviewed:
2014-03-27 / PA
Page:
1 of 18
Operating instruction
APR SR 200 full face
mask

Drawn up by:
2010-09-13 / RK
HI-SR 200 USA
Revision:
02
Reviewed:
2014-03-27 / PA
Page:
2 of 18
General information
The SR 200 full face mask can be used in three configurations:
Together with filters/cartridges from the Sundström filter range in
accordance with NIOSH approval label.
Together with Powered Air-Purifying Respirator (PAPR) with filters
/ chemical cartridges from the Sundström filter range in accordance
with NIOSH approval label.
Together with compressed air attachment SR 307 and SR 358 or
SR 359 in accordance with NIOSH approval label.
When selecting equipment for SR 200 some of the factors that
should be taken into account are as follows:
•Type of pollutant
•Concentrations
•Work intensity
•Protection requirements in addition to respiratory protective advice.
Risk assessment should be carried by a person who has suitable
training and experience in the area.
User´s Instruction for SR 200 should be read before use.

Drawn up by:
2010-09-13 / RK
HI-SR 200 USA
Revision:
02
Reviewed:
2014-03-27 / PA
Page:
3 of 18
2.1 Unpacking
2.2 Packing list
Check that the equipment is complete in
accordance with the packing list, and that
no transport damages have occurred.
Packing list:
Full face mask
Filter adapter
Pre-filter holder
Pre-filter
Cleaning tissue
Test disc
User instruction
Approval Label
2.3 Filter selection
To fit the filter in a mask
Check that you have selected the right
filter / filter combination and that the
used-by date has not been passed.
Press the filter/cartridge together so that
the arrows on the particulate filter point
towards the chemical cartridge.

Drawn up by:
2010-09-13 / RK
HI-SR 200 USA
Revision:
02
Reviewed:
2014-03-27 / PA
Page:
4 of 18
Fit the filter/combined filter in the filter
adapter SR 280-3 so that the arrow on
the filter points towards the filter adapter.
Carefully check that the edge of the filter
is in the internal groove of the filter
mounting.
Fit pre-filter SR 221 in the pre-filter holder
and press it into place on the filter.
Turn the filters into the mask.
Screw until the thread reaches the seal at
the bottom of the filter connection, then
another 45 degrees.

Drawn up by:
2010-09-13 / RK
HI-SR 200 USA
Revision:
02
Reviewed:
2014-03-27 / PA
Page:
5 of 18
2.5 Inspection points before use
Check that the mask is complete,
correctly assembled, thoroughly cleaned
and undamaged.
Check particularly carefully the inhalation
and exhalation membranes and their
seats.
The membranes are consumables and
must be replaced if there are any signs
of damage or ageing.