Sunjoy L-BB050PCO-1 User manual

Production Number: XXXXXXXX Made In China 1/ 3
ASSEMBLY INTRUCTION
ITEM#：L-BB050PCO-1
IMPORTANT:
For technical assistance on assembly or replacement parts, you can call us toll-free at 1 [phone] from 8 AM.
EST to 8 PM PST. You may email to customer[email protected]m or visit www.sunjoyonline.com to place your
order or fax your parts replacement order form (which included in the packaging) together with your purchase receipt to
1 [phone] for assistance.

Production Number: XXXXXXXX Made In China 2/ 3
PARTS LIST
PART#
DESCRIPTION
QTY
A
Big bird
1
B
Little bird
2
C
Pot
1
D
Connector
1
E
Crane
3
F
Leg 1
3
G
Leg 2
3
H
Bottom base
1
HARDWARE PACK
PART#
DESCRIPTION
QTY
AA
Stud M6*35
6
BB
Bolt M6*35
6
CC
Bolt M6*20
3
DD
Bolt M6*15
3
EE
Wrench M6/M8
1
FF
Nut M6
12
GG
Flat washer M6
15
HH
Stud M8*30
3
II
Nut M8
3
JJ
Flat washer M8
3
*Assembly requires a screwdriver (not supplied)

Production Number: XXXXXXXX Made In China 3/ 3
ASSEMBLY STEPS
CAREAND MAINTENANCE:
To extend the life of garden unit, cover it in bad weather. Due to natural properties of steel material, if rust develops,
please clean rust area by sanding slightly (other gazebos state oil, not sandpaper…), then wipe thoroughly and apply
touch-up paint if possible.
Limited Warranty:
This limited warranty is extended to the original purchaser and applies to defects in materials and workmanship of your
item provided the item is maintained with care and used only for personal, residential purposes.
The item is warranted to be free from defects in material or workmanship for a period of 6 months. If any defect is
found, please call our customer service department at 1 [phone] for help. The manufacturer will not cover
transportation or delivery costs, nor compensate the individual or any outside party for assembling or disassembling the
product. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Fig.1: Put leg 2 (G) at the inner side of the crane, then connect with bolt (BB), flat washer (GG) and nut (FF); connect
leg 1 (F) in the same way.
Fig.2: Insert the end of bolt (AA) without the "-" symbols into the holes leg 1 (F)/ leg 2 (G), and tighten with a
screwdriver.
Fig.3: Connect leg 1 (F)/ leg 2 (G) and bottom base (H) with bolt (AA), flat washer (GG) and nut (FF).
Fig.4: Connect connector (D) and crane (E) with bolt (CC).
Fig.5: Insert the end of bolt (HH) without the "-" symbols into the holes of pot (C), and tighten with a screwdriver.
Fig.6: Attach connector (D) to pot (C) with bolt (HH), flat washer (JJ) and nut (II).
Fig.7: Connect big bird (A) to pot (C) with bolt (DD) and flat washer (GG).
Fig.8: Connect little bird (B) to pot (C) with bolt (DD) and flat washer (GG).
Fig.9: Tighten all the bolts with wrench (EE) and screwdriver.