Sunricher SR-2300TR-G3-RGBW-US User manual

DALI RGBW Touch Controller 09.230WU6.04158
012
3
4
5
6
7
89
012
3
4
5
6
7
89
(x10)
(x1)
Rotary switches for setting start
DALI address number (0-63),
the number equals to tens
position plus units position
D2 D2
43.58 mm
65.58 mm
Function introduction
Important: Read All Instructions Prior to Installation
Front side
Back side
DALI signal output
DALI Wall Panel
Controller
83.00 mm
19.4 mm
Product Data
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Safety & Warnings
10*(0~9) for setting
tens position
1*(0~9) for setting
units position
D1D1
75x120x29.1mm
Output DALI signal
Operation Current 4mA
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions
Power Supply Supply By DALI Bus
• Touch sensitive.
• Glass interface(white & black).
• Comply to DALI standard protocol IEC 62386-102, IEC
62386-207 and in compliance with DALI products from
other international incorporation.
• 3 light zones are available for switch, dimming and RGB
color control, each zone can control 4 DALI addresses.
• Enable to set start DALI address number (0-63) for the 4
zones by rotary switches on the back.
• Built-in 8 Color Sequences
Waterproof grade Ip20
ON/OFF button
Red channel: click to turn ON/OFF,
press and hold down to
increase/decrease light intensity
RGB color wheel
Blue channel: click to turn ON/OFF,
press and hold down to
increase/decrease light intensity
Green channel: click to turn ON/OFF,
press and hold down to
increase/decrease light intensity
White channel: click to turn ON/OFF,
press and hold down to
increase/decrease light intensity
Play/Pause button, click to
play/pause running effects, press
and hold down to speed up/down
Click to get CW, NW, WW
mixed by RGB
Brightness button, press and hold
down to increase/decrease light
intensity
3 light zones, click to select, press
and hold down to turn ON/OFF
Wiring diagram
AC Power
50/60Hz
L
N
G
V+
V-
OUTPUT
INPUT
12V/24V/36V
CV PSU
DALI BUS
D1
D2
123
4
GND
Connect wi th R GBW LED Strip
V+ V+
R- R-
G- G-
B- B-
W- W-
123
4
GND
Connect wi th R GBW LED Strip
V+ V+
R- R-
G- G-
B- B-
W- W-
012
3
4
5
6
7
89
012
3
4
5
6
7
89
(x10)
(x1)
D2 D2
DALI Wall Pa nel
Contr oller
D1D 1

Installation
Operation
1. Set start DALI address number for the zones by rotary switches on the back
Set the number as X (0-63):
Zone number 1 will control DALI addresses X, X+1, X+2 and X+3,
Zone number 2 will control DALI addresses X+4, X+5, X+6 and X+7,
Zone number 3 will control DALI addresses X+8, X+9, X+10 and X+11,
Note: if X is set as 63, zone 1 will control DALI address 63, 00, 01 and 02, zone 2 will control address 03, 04, 05
and 06, zone 3 will control address 07, 08, 09 and 10.