superbrightleds EL-S Series User manual

LED Emergency Light
EL-Sx
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Included Parts
Specications
EL-Sx
Total Power Consumption 6 W
Operating Voltage Range 120/277 VAC
Operating Temperature 14°–122° F (-10°–50° C)
Operating Humidity <90%
Fixture Weight 2.6 lb (1.2 kg)
Battery Type 6V4 5AH Sealed Lead Acid
Maximum Mounting Height 8.35 ft (2.54 m)
1 - xture
1 - hardware kit
¹
¹Limited 2-year warranty on battery.
Testing
Manual Test
Test button can be held to illuminate lights for manual
testing purposes.
Wiring Diagram
User Manual
120 V Wiring
277 V Wiring
BLACK
WHITE
ORANGE
120 V POWER
NEUTRAL
N/C
BLACK
WHITE
ORANGE
N/C
NEUTRAL
277 V POWER
BLACK
WHITE
ORANGE
120 V POWER
NEUTRAL
N/C
BLACK
WHITE
ORANGE
N/C
NEUTRAL
277 V POWER
EL-SW
Rev Date: V2 04/09/2020
Important: Read all instructions prior to installation. SAVE THESE INSTRUCTIONS.
Important Safeguards
Read and follow all safety instructions. When using electrical
equipment, basic safety precautions should always be followed
including the following:
• This product should be installed and serviced by a certied
electrician in accordance with applicable national, state, and
local building and electrical codes.
• Light must be maintained, tested, and serviced in
accordance with all applicable National Fire Protection
Association (NFPA) and local codes.
• To reduce the risk of electric shock, ensure that the main
power source and circuit breakers are switched o󰀨 before
performing any installation or wiring procedures.
• Ensure xture is securely mounted and mount will support
weight of the xture. Failure to properly support xture may
result in damage or injury, for which the manufacturer does
not assume responsibility.
• Equipment should be mounted in locations and at heights
where it will not be subjected to tampering by unauthorized
personnel.
• Indoor use only—do not use outdoors.
• Do not mount near gas or electric heaters or any other
radiant heat sources.
• Use caution when handling or servicing the battery pack.
• For conduit wiring installation, use exible conduit only
• The use of accessory equipment not recommended by the
manufacturer may cause an unsafe condition.
• Do not use this equipment for anything other than its
intended use.

Installation Instructions
1. Carefully remove mounting panel by using a at-head
screwdriver to release tabs in two lower slots.
2. Remove appropriate knockouts for wiring and mounting
from real panel.
3. Run wiring through mounting plate and connect
wiring to junction box. Cap unused wire.
(refer to wiring diagram)
Note: Orange and black wires should
never be connected at the same time.
4. Securely attach mounting panel to wall
or junction box with hardware.
5. Use a screwdriver to remove battery retaining bracket
from light and securely connect battery. Reinstall
battery retaining bracket.
6. Reattach light assembly to mounting
panel (FIG 3).
7. Apply power and allow battery pack to charge for at
least 24 hours before initial use/test.
8. After 24-hour period, press test button to make
certain lights are functioning as intended.
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
LED Emergency Light
EL-Sx
User Manual
11.80in
299.72mm
5.20in
132.08mm
16.08in
408.5mm
4.63in
117.65mm
2.97in
75.38mm
2.97in
75.38mm
2.60in
66.04mm
1.72in
43.688mm
2.30in
58.42mm
2.30in
58.42mm
3.06in
77.80mm
6.01in
152.65mm
11.80in
299.72mm
5.20in
132.08mm
16.08in
408.5mm
4.63in
117.65mm
2.97in
75.38mm
2.97in
75.38mm
2.60in
66.04mm
1.72in
43.688mm
2.30in
58.42mm
2.30in
58.42mm
3.06in
77.80mm
6.01in
152.65mm
Test Button
PCB
PCB Plug
Fixture
Battery
Retaining Bracket
Mounting Panel
Test Button
PCB
PCB Plug
Fixture
Battery
Retaining Bracket
Mounting Panel
¹
¹Limited 2-year warranty on battery.
Rev Date: V2 04/09/2020
Important: Read all instructions prior to installation. SAVE THESE INSTRUCTIONS.