Swisher PowerBlade PBH-1590 User manual

PBH-1590
Honda Models
350 Rancher 4X4 04-06
350 Rancher 2X4 04-06
400 Rancher 4X4 04-06
May fit additional models see Master List
Front
Caution: Do not exceed 5 MPH with the blade or it’s brackets installed
Remove the mount plate for trail riding where extra ground clearance is needed
1602 Corporate drive
P.O. Box 67
Warrensburg, MO 64093
1-877-627-5860
13111

1
2
3
4
5
6
7
8
5
6
Item # Description Part #
1 Mount Plate 10411TK
2 Support Plates 10412TK
3 Carriage Bolt 10197
4 U Bolt NB724
5 Washer NB275
6 Nylock Nut 5/16-18 NB181
7 Clevis Pin 10305
8 Hair Pin #39 NB127
Assembly Instructions
Note. Right and Left direction are from the operator position. The lower skid plate, If so equipped, may need
to be removed. Please retain plate and hardware to be reinstalled if the plate is removed..
1. Assemble the Mounting Plate and the Support Plated as shown with the Carriage bolts, Washers, and
nuts ( Item 3,5, and 6 ). Note slotted holes in the Mount plate face toward the front of the ATV.
2. Place the U Bolts over the frame in the general area of the mounting holes.
3. Place the mount Kit up against the frame and install the Washers and nuts to a snug position
4. After all hardware has been install check the alignment of the plate to the ATV
5. Tighten the bolts securely