Swisher PowerBlade PBY-5510 User manual

PBY-5510
Yamaha Models
400 Kodiak
660 Grizzly
700 Grizzly
May fit additional models see Master List
Front
Caution: Do not exceed 5 MPH with the blade or it’s brackets installed
Remove the mount plate for trail riding where extra ground clearance is needed
1602 Corporate drive
P.O. Box 67
Warrensburg, MO 64093
1-877-627-5860
12971

Item # Description Part #
1 Right Side Mount Plate 10615TK
2 Cross Plate 10489TK
3 Left Side Mount Plate 10473TK
4 Carriage Bolt 5/16-18 X1 10216
5 Nylock Nut 5/16-18 NB181
6 Bolt M8-1.25 X25 NB723
7 Washer Flat NB275
8 Washed Split Lock NB159
9 Hair Pin #39 NB127
10 Clevis Pin 10305
1
2
3
4
5
6
7
8
9
10
Assembly Instructions
Note. These plates fit between the foot rest mount plates and the frame. After removing the foot rest bolts ,
save them for replacement if you remove the Mount Plate.
1. Assemble the mount plate as shown. Attach the right side plate to the cross plate with the 5/16
Carriage bolts and nuts. Do not tighten at this time. Attach the left side mount plate.
2. Remove the foot rest mounting bolts. Place the assembled mount plate between the frame and the
foot rest. Install the longer M8 bolts (4 Per Side) with the lock washer and the flat washer as shown.
Do not tighten. Repeat on the other side.
3. Push the mount plate to the rear of the ATV and tighten the M8 Bolts. Repeat on the other side.
4. Tighten the cross plate locknuts.
Yamaha
Footrest
Support