Swisher 2828 User manual

1602 CORPORATE DRIVE PO BOX 67 WARRENSBURG, MISSOURI 64093
PH 660. 747. 8183 AX 660. 747. 8650
swisherinc.com
MANU ACTURING QUALITY LAWN CARE EQUIPMENT SINCE 1945
Owner’s
Manual
Manual Lift
2828
IMPORTANT
Read and follow all
Safety Precautions
and Instructions
Before Operating this
Equipment.
Made In The
USA
ASSEMBLY
OPERATION
SERVICE AND ADJUSTMENT
REPAIR PARTS
2831 REV. 05-014
To maximize efficiency when using the 2643
Bucket and 2644 Skid Lift (which are built to
transport much heavier loads) use of a
properly rated winch rather than the 2828
Manual Lift is recommended .

The manufacturer’s warranty to the original consumer purchaser is: This
product is free from defects in materials and workmanship for a period of
one (1) year from the date of purchase by the original consumer
purchaser. We will repair or replace, at o
ur discretion, parts found to be
defecti e due to materials or workmanship. This warranty is subject to
the following limitations and exclusions:
1) Commercial Use The warranty period for any product used for
commercial or rental is limited to ninety (90) days
from the date of original purchase.
2) Limitations This warranty applies only to products which ha e
been properly assembled, adjusted, and operated in
accordance with the instructions contained within this
manual. This warranty does not apply to any product
of Swisher Mower Co., Inc., that has been subject to
alteration, misuse, abuse, improper assembly or
installation, or shipping damage.
3) Exclusions
Excluded from this warranty are normal wear, normal
adjustments, and normal maintenance.
LIMITED WARRANTY
2

In the e ent you ha e a claim under this warranty, you must return the
product to an authorized ser ice dealer. All transportation charges,
damage, or loss incurred during transportation of parts submitted for
replacement or repair under this warranty shall be borne by the purchaser.
Should you ha e any questions concerning this warranty, please contact us
toll-free at 1-800-222-8183. The model number, serial number, date of
purchase, and the name of the authorized Swisher dealer from whom you
purchased the product will be needed before any warranty claim can be
processed.
THIS WARRANTY DOES NOT APPLY TO ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES AND ANY IMPLIED WARRANTIES
ARE LIMITED TO THE SAME TIME PERIODS STATED HEREIN
FOR ALL EXPRESSED WARRANTIES.
Some states do not allow the limitation of consequential damages or
limitations on how long an implied warranty may last, so the abo e
limitations or exclusions may not apply to you. This warranty gi es you
specific legal rights and you may ha e other rights, which ary from state-
to-state. This is a limited warranty as defined by the Magnuson-Moss Act
of 1975.
Never make adjustments or repairs to lift with the AT
engine running.
3

• Read the manual. Learn to operate this machine safely.
• Keep the ATV operating speed LOW!!!!! Do not operate o er 5 MPH
(8KMH)
• Allow only responsible adults who are familiar with these instructions to
operate this machine. Ne er allow children to operate this machine.
• Be sure the area is clear of other people before operating. Children are often
attracted to the machine and the operating acti ity. Never assum e that
children will rem ain where you last saw them. Keep children under the
watchful care of another responsible adult.
• W atch for traffic when operating near or crossing roadways.
• Do not operate any accessory mounted to lift, if it has been dropped or
damaged in any manner. Repair as necessary.
• Dress properly. Do not operate when barefoot or wearing open sandals.
• Do not operate the machine while under the influence of alcohol or drugs.
• Ne er tamper with safety de ices. Check their proper operation regularly.
This Safety Alert Symbol indicates important messages in this
manual. W hen you see this symbol, carefully read the message that
follows and be alert to the possibility of personal injury.
Read this manual completely. Failure to observe the following safety instructions
could result in serious injury or death.
SAFETY PRECAUTIONS & DECALS
4

5
`
1. Mount handle to the lever weldment. Secure with roll pin. Slide handle grip over
handle (Applying soap to inside of grip may improve ease of assembly).
2. Mount lift to the front A V rack using mounting brackets, 5/16” carriage bolts, 5/16”
washer, and 5/16
” Nyloc nuts. he lift needs to be mounted in the center of the rack.
Position of the mounting brackets needs to be determined by the end user
depending on the type of A V and rack the lift is being mounted to.
3. Construct the cable assembly using chain connectors, cable, turnbuckle and
adjustment chain. Note: The turnbuckle should have the eyebolts extended out
to allow for final adjustment of the cable assembly.
4. Mount cable assembly to the lift. Raise handle to the vertical position.
5. Attach adjustment chain to bolt on the plow attachment. Adjust the chain to it’s
tightest position. For final adjustment, tighten turnbuckle until slack is removed.
6. Assemble cover to baseplate. Secure with ¼-20 screws.
. Attachments are raised by pulling the handle toward the oper
ator and resting on the
A V rack. Maximum lift is approximately 2 ½” to 3” at the cable.
INSTALLATION AND OPERATION O MANUAL LI T
TO ENSURE PROPER INSTALLATION, CAR ULLY
OLLOW ALL INSTRUCTIONS LISTED BELOW
PLOW ATTACHMENT
COVER
¼-20 SCREW
NYLOC NUT
5/16” WASHER
HANDLE
HANDLE GRIP
LEVER WELDMENT
ROLL PIN
BRACKET
5/16 CARRIAGE BOLT
CONNECTOR
TURNBUCKLE
ADJUSTMENT CHAIN
CABLE

MANUAL LI T ASSEMBLY
MANUAL LI T ASSEMBLYMANUAL LI T ASSEMBLY
MANUAL LI T ASSEMBLY
6
18
419
20
24
6
1
16
15
9
23
11
8
2
7
3
12
10
21
17
25
26
14
Item # QTY. Description Part #
1 1 Lever Weldment, Painted 2818 K
2 1 Main Shaft Weldment, Painted 2822 K
3 1 Connector, Manual Lift, Painted 2792 K
4 1 Handle, Manual Lift, Painted 2820 K
5 1 3/8-16 X 3 1/2 GR5 ZP NB649
6 2 3/8-16 X 1 GR5 ZP Bolt NB604
7 3 3/8-16 Nyloc Nut NB182
8 2 1/8 X 1 Cotter Pin NB126
9 1 3/16 X 1 Roll Pin NB123
10 4 5/16-18 X 3/4 Serr Flg Bolt NB596
11 2 Mounting Bracket, Painted 2791 K
12 1 Front Roller Mount, Painted 2793 K
13 2 3/8 SAE Washer NB272
14 4 5/16-18 X 2 1/4 Carriage Bolt NB110
15 4 5/16 X 1 1/4 OD Fender Washer NB579
16 8 5/16-18 Nyloc Nut NB181
17 1 Cable Assembly, Manual Lift 2824
18 3 3/16 Chain Connector ES077
19 1 ransmission Lever Grip 2427
20 1 Cover, Manual Lift 2794
21 2 Bushing .625 8048
22 1 Fairlead Roller .875 OD X 2.25 8005Z
23 1 Base Plate Weldment, Painted 2826 K
24 4 1/4-20 X 1/2 MSC ZP Hex Washer NB114
25 1 urn Buckle 2825
26 1 Adjustment Chain 2703

7
Notes

swisherinc.com
MANU ACTURING QUALITY LAWN CARE EQUIPMENT SINCE 1945
WHEN ORDERING PARTS, PLEASE HAVE THE
OLLOWING IN ORMATION AVAILABLE:
* PRODUCT – ________________
* SERIAL NUMBER - _______________
* MODEL NUMBER - _______________
TYPE - _______________
* PART NUMBER WITH PAINT CODE
* PART DESCRIPTION
TELEPHONE - 1-800-222-8183
AX - 1-660-747-8650
SWISHER MOWER & MACHINE CO. INC.
SWISHER MOWER & MACHINE CO. INC.SWISHER MOWER & MACHINE CO. INC.
SWISHER MOWER & MACHINE CO. INC.
1602 CORPORATE DRIVE
P.O. BOX 67
WARRENSBURG, MO 64093
MANUAL LI T
Owner’s
Manual
IMPORTANT
Read and follow all
Safety Precautions
and Instructions
Before Operating this
Equipment.
Manual Lifter
2828