Swisher PowerBlade PBP-3640 User manual

PBP-3640
Polaris
Hawkeye 300
May fit additional models see Master List
Front
Caution: Do not exceed 5 MPH with the blade or it’s brackets installed
Remove the mount plate for trail riding where extra ground clearance is needed
1602 Corporate drive
P.O. Box 67
Warrensburg, MO 64093
1-877-627-5860
12983
Partial Frame Illustration
Manual Lift
Strap Bracket

Item # Description Part #
7 Bracket-Lift Strap 12984TK
8 Spacer 7825Z
9 Bolt 5/16-18 X4 NB513
10 Washer NB275
11 Nylock Nut 5/16-18 NB181
Assembly Instructions
Note. Right and Left direction are from the operator position. The lower skid plate, If so equipped, may need
to be removed. Please retain plate and hardware to be reinstalled if the plate is removed.
Blade Mount Kit
1. Separate and Identify the parts to the Blade Mount and the Manual Lift Strap Bracket.
2. Place the U-Bolts over the foot Rest tubes adjacent to the frame braces.
3. Attach the plate with Washers and Lock nuts as shown, The blade mount tabs are pointing down and
to the front of the ATV, and snug the nuts
4. Center the plate, assuring proper clearance with the Drive shaft universal joint.
5. Tighten the nuts securely
Manual Lift Strap Bracket ( Only mount if using the manual lift kit)
1. Remove the bolts near the headlights.
2. Place bolt Bracket and three spacers into the hole and attach nut on the inside.
3. Repeat with the other side.
4. Slip Lift Strap through the hole and loop through itself.
Item # Description Part #
1 Mount Plate 12982TK
2 U Bolt 7874Z
3 Washer NB275
4 Nylock Nut NB181
5 Hair Pin #39 NB127
6 Clevis Pin 10305
1
2
3
4
5
6
7
8
9
10
11
Lift Strap Mounting