Swisher PowerBlade PBP-3580 User manual

PBP-3580
Polaris Models
Magnum 325 2X4 4X4 02
Expedition 425 4X4 02
Magnum 500 4X4 02
May fit additional models see Master List
Front
Caution: Do not exceed 5 MPH with the blade or it’s brackets installed
Remove the mount plate for trail riding where extra ground clearance is needed
1602 Corporate drive
P.O. Box 67
Warrensburg, MO 64093
1-877-627-5860
13058

1
2
3
5
6
4
Front
Item # Description Part #
1 Mount Plate 10611TK
2 U Bolt 7873Z
3 Washer Flat NB275
4 Nylock Nut 5/16-18 NB181
5 Hair Pin #39 NB127
6 Clevis Pin 10305
Assembly Instructions
Note. Right and Left direction are from the operator position. The lower skid plate, If so equipped, may need
to be removed. Please retain plate and hardware to be reinstalled if the plate is removed..
1. Remove the front skid plate. Trim the edge back to the factory notch as shown (Approximately ¾
Inch). Replace the skid Plate. Tighten securely.
2. Place the four U Bolts over the frame on each side with one in front of the front foot peg support, and
one behind.
3. Place the mount plate up against the frame and attach the washers and nuts. Note locate the plate
as shown with the front label toward the front. (Tabs are offset to the left slightly)
4. Tighten all bolts securely.
Remove edge of skid plate as shown Factory Notch