Swisher PowerBlade PBP-3570 User manual

PBP-3570
Polaris Models
325 Magnum 2X4 & 4X4 01 & Older
425 Expedition 4X4 00
500 Magnum 4X4 01 & Older
500 Magnum RMK 4X4 02
May fit additional models see Master List
Front
Caution: Do not exceed 5 MPH with the blade or it’s brackets installed
Remove the mount plate for trail riding where extra ground clearance is needed
1602 Corporate drive
P.O. Box 67
Warrensburg, MO 64093
1-877-627-5860
13183

1
23
5
6
4
Front
Item # Description Part #
1 Mount Plate Right 10608TK
2 Mount Plate Left 10609TK
3 Cross Plate 10453TK
4 Strap Bar 10454TK
5 Clevis Pin 10305
6 Hair Pin #39 NB127
7 Bolt 5/16-18 X NB138
8 U Bolt 5/15-18 7873Z
9 Carriage Bolt 10216
10 Nylock Nut NB181
Assembly Instructions
Note. Right and Left direction are from the operator position. The lower skid plate, If so equipped, may need
to be removed. Please retain plate and hardware to be reinstalled if the plate is removed..
1. Assemble Right Mount Plate and Left Mount plate to the Cross Plate using Carriage bolts ( Item 9),
and Nylock Nuts ( Item 10) and snug the fasteners .
2. Place the mount plate up against the frame with the front toward the front of the ATV
3. Drop the U Bolts over the foot rest supports on the right side and attach with Nylock Nuts .
4. Place the long bolts ( Item 7 ) into Strap Bar (Item 4 ) and place the close spaced bolts over the rear
foot rest support on the left hand side. Attach with Nylock Nuts.
5. Align the plate to the center of the ATV and tighten all hardware securely.
7
8
9
10