T&S B-0315-LN User manual

Installation and
Maintenance
Instructions
Mixing Faucet
B-0315
(B-0315-LN shown)
Deutsch: Installations-und
Wartungsanleitungen
Español: la Instalación y las
Instrucciones de
Mantenimiento
Français: les Instructions
d’Installation et
d’Entretien
Limited One Year Warranty
T&S warrants to the original purchaser (other
than for purposes of resale) that such product is
free from defects in material and workmanship
for a period of one (1) year from the date of pur-
chase. During this one-year warranty period, if
the product is found to be defective, T&S shall,
at its options, repair and/or replace it. To obtain
warrantyservice,productsmustbereturnedto...
T&S Brass and Bronze Works, Inc.
Attn: Warranty Repair Department
2 Saddleback Cove
Travelers Rest, SC 29690
Shipping, freight, insurance, and other trans-
portationcharges ofthe productto T&Sand the
return of repaired or replaced product to the
purchaseraretheresponsibilityofthepurchaser.
Repair and/or replacement shall be made within
a reasonable time after receipt by T&S of the
returned product. This warranty does not cover
Items which have received secondary finishing
orhave beenalteredor modifiedafterpurchase,
or for defects caused by physical abuse to or
misuse of the product, or shipment of the prod-
ucts.
Any express warranty not provided herein,
and any remedy for Breach of Contract which
might arise, is hereby excluded and disclaimed.
Any implied warranties of merchantability or fit-
ness for a particular purpose are limited to one
year in duration. Under no circumstances shall
T&S be liable for loss of use or any special con-
sequential costs, expenses or damages.
Some states do not allow limitations on how
long and implied warranty lasts or the exclusion
or limitation of incidental or consequential dam-
ages,so theabove limitationsorexclusions may
not apply to you. Specific rights under this war-
ranty and other rights vary from state to state.
P/N: 098-012427-45
Date: 990609
Drawn: CW
Checked: MAB8-10-99
Approved: MVW8-6-99

Exploded View
*Some items are listed for instructional
purposes and may not be sold as separate parts.
Side View
9
1
1
4
3
10 11
6
2
Front View
8
2
6 3
5
7
12
2

Part Number Guide
Faucet Assemblies
1Body, Wash Sink *
2Asm, Spindle, Eterna 005960-40
3Handle, 4 Arm Kitchen 002521-45
4Button, Index Handle, Blue- Cold 001660-45
5Button, Index Handle, Red- Hot 001661-45
6Screw, Lever Handle 000922-45
7Asm, Coupling Flange 1/2 002893-40
8Flange, 1/2 NPT *
9Nut, Flange Coupling *
10 Insert, Flange *
11 Washer, Coupling Nut 001019-45
12 Asm, Gooseneck w/ Tip 120X
3

4
General Instructions
Nozzle Installation:
Note: Nozzles should be installed
first.
1. Shut off water supply and drain
lines. Apply Teflon tape or pipe joint
compound to threaded end of no.12.
2. Tighten no.12 firmly by hand into
no.1.
12
apply Teflon
tape to
threads
before
installing
no.1
FaucetInstallation:
1.Drill (2) two holes,approximately
1-1/4”[3cm] diameter inwallwith 3”
[7 cm] vertical centers, where you are
installingno.1.
3
[7 cm]
2. Apply Teflon tape or pipe joint
compound to water supply lines.
3. Connect no.7to water supply lines
by attaching no.8with eccentric
centers onto nipple supplied by
others and tighten no.8against wall.
Make sure no.11 is in place. Nut
behind wall to be supplied by others.
Trim supply lines if necessary.
water supply line
11 8
wall
water supply line
nut
(supplied by others)
(supplied by others)
8
1
4. Turn on water supply and check
for leaks.

5
Instrucciones Generales
Instalación de la Boquilla:
Nota: Las boquillas deben de ser
instaladas primero.
1. Cierre la fuente de agua y desagüe
las tuberías. Aplique cinta de Teflon
o compuesto de coyuntura al extremo
con rosca de la parte No.12.
2.Firmementeaprieteamanolaparte
No.12 entre laparte No.1.
12
Aplique
cintade
Teflon a las
roscas antes
deinstalar
laparteNo.1
Instalación de la Canilla:
1. Perfore (2) dos huecos,
aproximadamente de 1-¼” [3 cm] de
diámetro en la pared con centros
verticales de 3” [7 cm] donde la parte
No.1 será
instalada.
[7 cm]
2.Aplique cinta de Teflon o
compuesto de coyuntura a las líneas
de agua.
3. Conecte la parte No.7 a las líneas
de surtido juntando la parte No.8con
centros excéntricos al tubo surtido
por otros y apriete la parte No.8
contra la pared. Asegúrese quela
parte No.11 este en su sitio. La
tuerca detrás de la pared será
surtida por otros. Si es necesario
recorte las líneas de agua.
11 8
Pared
Línea de agua
Tuerca
(surtido por otros)
8
1
4. Abra la fuente de agua e
inspeccione por filtraciones.
Línea de agua
(surtido por otros)

6
Instructions
Générales
L’Installation De L’Ajutage
Noter: Les ajutages devoir être
installer au début.
1. Fermer la réserve de l’eau et
égoutterla tuyauterie. Appliquer le
ruban en Téflon ou le composé pour
les tuyaux à l’extrémité de Nº.12
avec les filets.
2.ResserrerNº.12 fermement par le
main dans Nº.1.
12
appliquer le
ruban en
Téflon aux
filets avant
l’installation
de Nº.1.
L’Installation Du Robinet
1. Percer (2) deux trous, avec un
diamètre3 cm dans le mur avec des
centres vérticales de 7 cm, où vous
allerinstaller Nº.1.
3
[7 cm]
2.Appliquer le ruban en Téflon ou le
composé pour les tuyaux aux filets
des tuyaux qui fournir l’eau.
3. Brancher Nº.7aux tuyaux qui
fournir l’eau en branchant Nº.8avec
les centres excentriques sur le raccord
fournir par les autres et resserrer
Nº.8contre lemur. Soyez certain que
Nº.11 être à sa place . L’écrou
derrière le mur fournir par les autres.
Couper un peu les tuyaux qui fournir
l’eau si nécessaire.
le tuyau qui fornir l’eau
11 8
le
mur
L’écrou
(fournir par les autres)
8
1
4.Recommencer l’eau et vérifier s’il
y a des fuites.
le tuyau qui fornir l’eau
(fournir par les autres)

7
Allgemeine Anleitungen
Installationdes
Strahlauslaufes:
Hinweis:Strahlausläufesollten als
erstesinstalliertwerden.
1.Wasserzufuhr abdrehen und Rohre
leerlaufen lassen. Teflonband oder
RohrkittzumGewindeendederNr. 12
auftragen.
2.Nr. 12 fest mit der Hand in Nr. 1
eindrehen.
12
Teflonband
zum
Gewinde
auftragen,
bevor Nr. 1
installiert
wird.
Installation des
Wasserhahnes:
1.BohrenSiezwei(2) Löcher,
ungefähr 3 cm Durchmesser mit
einemAbstand von 7 cm von
LochmittezuLochmitte, in dieWand,
in der Nr. 1installiert wird.
3
[7 cm]
2.Teflonbandoder Rohrkittzum
GewindederWasserzufuhrleitungen
auftragen.
3.Verbinden SieNr. 7zur
Wasserleitung, indem Sie Nr. 8mit
versetzter Mitte auf den Rohrnippel
(nichtin der Lieferung enthalten)
befestigen, und fest gegen die Wand
anziehen. StellenSie sicher,daß sich
Nr.11 in der korrektenPosition
befindet. DieMutterhinterderWand
ist nicht in der Lieferung enthalten.
Fallserforderlich,Zufuhrleitungen
entsprechendkürzen.
Wasserzufuhrleitung
11
Wand
Mutter
(Nicht in der Lieferung enthalten)
8
1
4. Wasser andrehen und auf Dichtheit
prüfen.
Wasserzufuhrleitung
(Nicht in der Lieferung enthalten)
8

T&S BRASS AND BRONZE WORKS, INC.
A firm commitment to application-engineered plumbing products
2 Saddleback Cove, P.O. Box 1088, T & S Brass-Europe
Travelers Rest, SC 29690 ‘De Veenhoeve’
Phone: [phone] Oude Nieuwveenseweg 84
Fax: [phone] CW Nieuwveen
E-mail: [email protected] The Netherlands
RELATED T&S BRASS PRODUCT LINE
B-0525
Swivel Goosenect Spout
WallMounted
B-0535
Rigid Gooseneck
Spoutw/ Spray
WallMounted
8