Teknion height-adjustable bench Operating and maintenance instructions

System Link - HAB to Interpret (HABFLS1) Part and Product Identification
For Customer Support please contact
[email protected]
Section:
Description: Page No:
Date:
Rev. No: 2
SYSTEM LINK - HEIGHT-ADJUSTABLE BENCH (HAB) TO INTERPRET
FRAMES & WORKSURFACE
May 2017 1 of 4
HABL_102
height-adjustable bench Installation Guides
A
height-adjustable
Bench (HAB)
Frame
B
Interpret
Frame
C
IMPORTANT: The System Link is
not intended to provide structural
support to the Interpret Frame. The
System Link MUST ONLY be
installed to Complete Interpret Frames
with End Legs.
End Leg
A - System Link Top Bracket
Sub-Assy, HAB
to Interpret (N09-5120) x1
B - System Link Bottom Bracket, HAB to
Interpret (A16-3051) x1
C - System Link Cover, HAB to Interpret
(A16-3200) x1
D - 1/4-20 UNC. Nut Hex Keps Zinc
(E03-0059) x2
E - 1/4-20X3/4" Mach. Screw Quad Truss
(E01-2010) x2

Section:
Description: Page No:
Date:
ATTACH TOP BRACKET TO INTERPRET FRAME PLACE BOTTOM BRACKET IN PLACE
HABL_102
2 of 4
May 2017
SYSTEM LINK - HEIGHT-ADJUSTABLE BENCH (HAB) TO INTERPRET
FRAMES & WORKSURFACE
height-adjustable bench Installation Guides
Underside View
A
Center
Beam
Interpret
Frame
NOTE: DO NOT
fully tighten Nuts
B
A
D
STEP 2: Place Bottom Bracket in place by inserting Top Bracket studs into Bottom Bracet
slots. Fasten Nuts provided but DO NOT fully tighten.
STEP 1: Using Interpret Frame Nuts fasten Top Bracket to Center Beam of Interpret Frame, as
shown.

Section:
Description: Page No:
Date:
ATTACH BOTTOM BRACKET TO HAB FRAME TIGHTEN BRACKET NUTS
HABL_102
3 of 4
May 2017
SYSTEM LINK - HEIGHT-ADJUSTABLE BENCH (HAB) TO INTERPRET
FRAMES & WORKSURFACE
height-adjustable bench Installation Guides
Reverse View
E
A
B
Stretcher Bar -
HAB Frame
D
NOTE: Make sure to
level both Frames
before tightening the
System Link Nuts
STEP 4: Fully tighten Top Bracket Nuts to secure Bottom Bracket in place.
STEP 3: Align Bottom Bracket & HAB Frame Stretcher Bar holes. Slide Bottom Bracket up &
fasten it to HAB Frame Stretcher Bar with Mach Screws provided.

Section:
Description: Page No:
Date:
ROUTE CABLES THROUGH SYSTEM LINK INSTALL FRAME LINK COVER
HABL_102
4 of 4
May 2017
SYSTEM LINK - HEIGHT-ADJUSTABLE BENCH (HAB) TO INTERPRET
FRAMES & WORKSURFACE
height-adjustable bench Installation Guides
Underside
View
OPTIONAL
Connects to
Interpret
Connects
to HAB
C
STEP 6: Insert the Top Bracket hooks into the vertical slots on the System Link Cover and
allow Cover to slide slightly down..
STEP 5: Route Cables through System Link to electrically connect both systems.