Topens TEW3 User manual

1
Exit Wand
Installation and Operation Instructions
(Item NO.: TEW3)
WAND SENSOR with 50 feet (15
meters) 5-core cable (1 PC)
Range adjustment board (1 PC)
Adapter board (1 PC):
*Only need to be used
with some models of
TOPENS gate opener
C030414
VER 21a

2
Thank you for your purchasing of the EXIT WAND. This product is designed to be used with most brands Gate
Opener by providing hands free operation of your gate. An adapter PCB is to be added when it is used with
some models of TOPENS gate opener. The gate opens automatically when the wand senses the vehicle
moving past. The EXIT WAND is comprised of three elements: the WAND with 5-core cable, range adjustment
board and adapter board for some models of TOPENS gate opener.
Installation Overview
NOTE: Keep the WAND and the cable uncovered before the function has been tested OK.
Definition of the 5 –core cable

3
Wire connection
STEP 1: Insert the adapter board into the socket of the control board before wiring the WAND. Only the
TOPENS KD902&AT1202 swing gate opener and the RK990&RK1200&CK1200 need to use the adapter
board. You can read the user manual of the opener to check if the adapter board is needed or not.
STEP 2: Wiring the WAND to the control board and range adjustment board. Following are the
examples to a few models of TOPENS gate opener. More details please refer to the user manual of the
gate opener.
Wiring Diagram of the wand to the A series swing gate opener
Wiring Diagram of the wand to the AD/PW series swing gate opener

4
Wiring Diagram of the wand to the KD902&AT1202 swing gate opener
(Need to plug the adapter board to the control board at first)
Wiring Diagram of the wand to the DK series sliding gate opener
Wiring Diagram of the wand to the RK990&RK1200&CK1200 sliding gate opener
(Need to plug the adapter board to the control board at first)

5
STEP 3: Power on the gate opener to test. Power off the exit wand and turn the sensitivity board
clockwise to increase the sensitivity, turn it counter-clockwise to decrease the sensitivity. If the
sensitivity is still too high when the sensitivity board has been adjust to Min., you can disconnect the
sensitivity board and ensure the YELLOW wire of the wand is floating (wired to nothing else) to try it
again.
Troubleshooting
1. Ensure all the wiring connections are correct before testing.
2. Ensure there is no moving object around the wand and then try it again.
TOPENS Website
www.topens.com
Any question, please do not hesitate to contact us:
E-mail: [e-mail]
Kindly include your Product Model, Purchasing Date & Site, Order #, and your contact information. All
your concerns will be replied within 24 hours.
Tel: [phone] (China)
Mon-Fri 9:00AM-5:30PM (UTC +08:00)