Toro 79181 User manual

Printed in USA
FORM NO. 3316–110
INSTALLATION
INSTRUCTIONS
MODEL NO. 79181
38” ANTI-SCALP KIT
for Lawn Tractor
Loose Parts
DESCRIPTION QTY. USE
Wheel Bracket, LH 1
Wheel Bracket, RH 1
Install wheel brackets
Nut Lock /-18 5 Install wheel brackets.
Screw /-18 x /5
Wheel 2
Wheel Bolt 2Install wheels.
Nut Lock /-16 2

Installation Instructions
2
Installation
POTENTIAL HAZARD
•A blade that is worn or damaged could
break apart and pieces could be thrown at
bystanders or at you as you use the mower.
WHAT CAN HAPPEN
•Pieces of blade that may be thrown could
seriously injure or kill you or bystanders.
HOW TO AVOID THE HAZARD
•Periodically inspect the blade for wear and
damage. Immediately install a new blade if
it is worn or damaged.
Remove the mower from the tractor; refer to the
operator’s manual.
Turn the mower upside down.
1. Mount the wheel brackets to the mower deck
with / – 18 x /” screws and / – 18 lock
nuts (Fig. 1).
Figure 1
1. Wheelbracket
2. Screw 3. Lock nut
2
13
2. Mount the wheels onto the wheel brackets with
wheel bolts and /–16 lock nuts (Fig. 2). Use
the same hole height on both sides. Refer to
adjusting mower wheels.
Figure 2
1. Wheel
2. Wheelbracket 3. Locknut 4. Wheel bolt
1
2
3
4
Install the mower onto the tractor; refer to the tractor
operator’s manual.
Adjusting Mower Wheels
The mower front wheels are to guide it over uneven
ground. The height of these wheels can be changed to
closer match the height-of-cut selected for the mower.
1. To change the height of mower wheels remove
wheel mounting bolt and change hole into which
it is mounted (Fig. 2).
2. Use the top hole for low height-of-cut and the
bottom hole for high height-of-cut (Fig. 2).