Tumbl Trak Quick Flex Bar User manual

Parts List
Assembly Instructions
Thank you for purchasing
the Quick Flex Bar to be
used with the original Tumbl
Trak™. This product is not
designed to be used with
other tumbling tracks or
trampolines. We hope you
will enjoy years of use of
this product.
After opening the boxes,
please check the parts list to
make sure all pieces have
arrived in good condition. If
you have any questions
during this assembly
process, please call
customer service
at 1-800-331-4362.
Quick
Flex Bar
NOTE: Tumbl Trak equipment is not recommended for
the use in Parkour/Free Running related activities.
Parts List
(2) Brackets
(2) PTO Pins
(2) Bar Pads
(1) Bar Strap
(1) Bag
(2) Bar Pads
(1) Bag to hold everything
(2) Brackets
(2) PTO Pins
(1) Bar Strap
with Ratchet
Any questions or problems, please call Tumbl Trak at [phone]

Locate the leg of your Tumbl Trak on which you want
to place the Quick Flex Bar bracket. Remove the PTO
pin of Bracket #1 and open the hinged portion of the
bracket.
Slide Bracket #1 into position,
placing it tightly against the leg.
Close the hinge and replace the
PTO pin into the hole on the
“U” (hook) part of the bracket.
Tighten the ratchet as tight as you can. You will
then want to bounce on the strap a few times and
tighten again. Make sure to lock down the ratchet
when you have reached the desired tightness.
Step
5:
Step
1:
Step
2:
Attach the non ratchet end of the
strap to Bracket #1.
Failure to attach properly could
result in injury.
Step
3:
Attach the end of the strap with the ratchet to Bracket #2.
Remove the PTO pin and open the hinged bracket. Slide
Bracket #2 on to the opposite leg, placing it tightly against
the leg. Close the hinge and replace the PTO pin into the
hole. Begin to tighten the ratchet. You will want to push down on
the bracket to make sure it is tight to the Tumbl Trak.
Step
4:
To watch the Quick Flex Bar in use visit the training
tips section of our website, www.tumbltrak.com
Step
6:
Place the two
provided bar
pads over the
ratchet for safety.
Enjoy the Quick
Flex Bar!
NOTE: If you have trouble ratcheting the
Quick Flex Bar, stop and find the end of
the strap. Pull the end of the strap with the
thick webbing away from the ratchet.
Begin tightening the ratchet again.