U-Line H-6304MAH User manual

PAGE 1 OF 2 0921 IH-6304MAH
1- 800-295-5510
uline.com
2 DRAWER OFFICE
LATERAL FILE CABINET
H-6304MAH
PARTS
Adjustable Glide x 4 File Clip x 8 Long Metal Bar x 2 Short Metal Bar x 4Metal Handle x 2
Screw x 6
M6 x 40 mm
Key (Set of 2) x 1
A B C D E
GF
ASSEMBLY
Figure 1
NOTE: Assemble on a smooth, non-marring
surface to avoid scratching.
NOTE: Check that all parts are included.
1. Lock drawers. With second person, set file cabinet
on side.
2. Insert adjustable glides (A) on bottom of file cabinet.
Glides can be adjusted to compensate for uneven
floors. (See Figure 1)
3. With second person, set file cabinet upright. Unlock
drawers. Remove handle (B) mounted inside drawer
and use same screws to attach handle to front of
drawer. Repeat for second drawer. (See Figure 2)
A
B
Figure 2
Two Person Assembly
Recommended
TOOL NEEDED
Phillips Screwdriver
Tighten
Tighten

PAGE 2 OF 2 0921 IH-6304MAH
1
-800-295-551
0
uline.com
ASSEMBLY CONTINUED
UNDER DESK MOUNTING
4. To hang files from side to side, attach one bar
clip (C) to each side of drawer and insert one
long metal bar (D). (See Figure 3)
5. To hang files from front to back, attach two bar
clips (C) to back of drawer and insert two short
metal bars (E). (See Figure 4)
C
D
Figure 3 Figure 4
C
E
File cabinet may be mounted under a desk or
credenza shell.
1. Open top drawer and locate plastic tab on drawer
slides. Push up on one tab and push down on
opposite tab to release drawer and remove.
2. Locate cam locks inside the cabinet near the top
panel. Using Phillips screwdriver, turn cam locks 1/4
to the left to unlock and then remove the top panel
from the cabinet.
3. Place file cabinet underneath desk or credenza
shell and align support bars with holes in desk or
credenza shell. Insert M6 x 40 mm screws (F) and
tighten using Phillips screwdriver.
NOTE: To attach cabinet to left side of a desk
or credenza, use four holes on left side of
cabinet. To attach cabinet to right side of a
desk or credenza, use four holes on right side
of cabinet.