Vision Fitness X6600HR User manual

MODEL X6600HRC ELLIPTICAL TRAINER
FITNESS
VISION
Guide
Assembly

To avoid possible damage to this Elliptical Trainer, please follow these assembly steps in the correct order. Before proceeding
though, enter your new Elliptical Trainer’s serial number here:
Refer to this number when calling for service, and also enter this serial number on your Warranty Card and in your own records.
Be sure to read your Owner’s Guide before using your new Elliptical Trainer.
If any parts, hardware or tools are missing, please call 1.800.335.4348, Extension 12
NOTE: It is recommended that you apply grease to the threads of each bolt as you assemble your Elliptical Trainer, to prevent loos-
ening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt.
Before you begin…
elliptical trainer
X6600HRC
7
STEP
3
STEP
1
STEP
2
STEP
5
STEP
4
STEP
6
STEP
8
STEP

5MM Allen Wrench
13MM Wrench Screwdriver
TOOLS & HARDWARE INCLUDED
4MM Allen Wrench
5MM L-Shaped Wrench
ORANGE BAG
55MM L x 8MM D Bolt
Quantity: 2 NyLock Nut
Quantity: 2
BLUE BAG
20MM L x 8MM D Bolt
Quantity: 6

4
1
STEP
• Slide the rubber cover onto the
console mast.
• Unfold the console cable and
attach it to the string located inside the
console mast. Guide the wire up
through the mast while simultaneously
sliding the console mast onto the
frame bracket.
• Bolt the mast to the frame using the
two bolts and two nuts; make sure
these are tight!
• Slide the rubber cover down over
the bolt heads.
ORANGE BAG
1
STEP
2
STEP
• Install the rubber boot over the top
of the lower right handlebar and slide
to the bottom corner.
RUBBER BOOT
2
STEP
3
STEP
• Mount the lower right handlebar to
the frame tube using one of the bolts
in the bag.
BLUE BAG
3
STEP

5
4
STEP
4
STEP
• Mount the upper right handlebar to
the frame and lower portion of
handlebar using two of the bolts in the
bag.
BLUE BAG
5
STEP
• Install the rubber boot over the top
of the lower left handlebar and slide
to the bottom corner.
RUBBER BOOT
5
STEP
6
STEP
• Mount the lower left handlebar to
the frame tube using one of the bolts
in the bag.
BLUE BAG
6
STEP

6
7
STEP
• Mount the upper left handlebar to
the frame and lower portion of
handlebar using two of the bolts in the
bag.
BLUE BAG
7
STEP
8
STEP
• Remove the four screws from the
back of the console. Plug the wire
connectors from inside the mast into
the console. The cable connectors
are slotted, so do not force the
connection!
• Mount the console to the mast using
the four screws. Do not pinch the
cable!
CONSOLE 8
STEP
621-D East Lake Street • P.O. Box 280 • Lake Mills. WI 53551
toll free 1.800.335.4348 • phone [phone] • fax [phone]
www.visionfitness.com
1999 Vision Fitness. All Rights Reserved. 7.99