WATSON Haven User manual

ASSEMBLY
Haven Table & Media Screens
V.21.0 12/2021 360.394.1300 watsonfurniture.com

2 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS
Screen Components
Screen
Table Bracket
Monitor Mount
Monitor Brackets
Lock Bar

3 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS
Hardware
BHSCS M6-1.0
x 16mm Black
(125278)
Wire Management
Clip(486911)
#10 X 1” Torx Head
Screw (0002147)
8-32 ZInc Plated Nut
(117011)
Tools
4mm Hex Bit T25 TorxElectric Drill
Socket
11/32”

4 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS
Attach the Table Bracket
Align the Table Bracket with the pilot holes in the worksurface and drive (7)
screws to secure it in place. Be sure to leave the square hole empty.
1.
#10 X 1” Torx Head
Screw (0002147)

5 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS
Drive Screws Into Screen
Drive (2) screws into the second lowest set of holes on the Screen until there is
1/8” gap between the screw head and the Screen.
2.
BHSCS M6-1.0
x 16mm Black
(125278)

6 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS
BHSCS M6-1.0
x 16mm Black
(125278)
Attach Screen to Bracket
Drive (4) additional screws and tighten the two
existing screws to secure the Screen in place.
3.

7 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS
BHSCS M6-1.0
x 16mm Black
(125278)
Secure Screen to Table Bracket
Slide the Screen onto the Table Bracket by aligning the (2) screw heads with the keyslots in the
bracket. Lower the Screen until it is fully seated in the keyslots.
4.

Attach Wire Management Clip
Align the wire management clip with the square hole in the Table Bracket. Then drive the screw
through the wire management clip until secure
5.
Wire Management
Clip(486911)
#10 X 1” Torx Head
Screw (0002147)
8 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS

9 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS
(Optional) Connect Power to Table Bracket
Situate the power unit in the associated power bracket. Slide the assembly on the included
studs on the side of the Table Bracket. Thread a nut on each stud to secure the unit in place.
6.
8-32 ZInc Plated Nut
(117011)

10 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS
(Optional) Attach Monitor Mount
Align the Monitor Mount with the holes in the Screen and secure it with (4) screws. The additional
holes can be used to raise or lower the Monitor. Attach the Monitor brackets to the back of the Monitor using the provided
Monitor mount hardware. The addtional holes in the brackets can be used to adjust the height of the Monitor. Plug in the
power cable and any additional data cables to the Monitor.
7.
BHSCS M6-1.0
x 16mm Black
(125278)
a.
b.

HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS
(Optional) Mount Monitor to screen
Hang the Monitor/bracket assembly on the Monitor mount and route cables down through the elastic cording.
8.

HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS
(Optional) Lock TV to screen
Slide the Lock Bar through the Monitor Mount and through both Monitor brackets. Place a lock through the hole in the
end of the lock bar. (Monitor not shown for visibility)
9.