WE-EF FLC122LED User manual

WE-EFLIGHTING
Installation and Maintenance
Instructions
Wall Luminaire Surface Mounted
FLC122LED
FLC142LED

This page intentionally left blank

WARNING :
This product to be installed by qualified personnel only.
Switch off and isolate the electrical supply during installation.
At no stage is the luminaire to be opened when live. Connections and cables are labelled,
before installation ensure the supply matches the luminaire designation.
ESD Sensitive Device:
This luminaire contains electrostatic sensitive devices. Do not handle the LED PCB or LED
connection leads without suitable ESD prevention methods in place. If in doubt contact WE-EF
LIGHTING or an authorised Sales partner. Warranty can be void if the correct handling
procedures are not observed.
Surge Protection:
Luminaires designated with the type code ‘+A’ will have an internal Surge Protection Device
(SPD) fitted.
For comprehensive protection of a luminaire installation against lightning and electrical
surges, it is essential to cover mains supply and data input lines at the distribution board
level, by using respective primary (Type 1) and secondary (Type 2) surge arrestors in
compliance with EN61643-11/IEC61643-1.
Ensure that all required surge protection measures are in place and activated prior to
luminaire installation. Disconnect luminaires before operating high-power devices such as,
for example, electrical arc welders.
Cleaning:
Apart from cleaning the product’s exterior surfaces, no special maintenance work is required.
DO NOT use high pressure cleaners on this luminaire
Notice:
Unless directed by this installation instruction, the luminaire is to be treated as Factory Sealed
with no user serviceable parts. If the luminaire is modified by anybody other than the original
manufacturer, the warranty will no longer be valid and shall become the full responsibility of the
modifying person/organisation. Claims based on defects attributable to improper installation
and/or application, and the consequences thereof,are also excluded.
If the supplied cable of the luminaire is damaged, it must be replaced by WE-EF or a WE-EF
authorized agent.
Installation Tools:
Mounting hardware used on this product includes fasteners with hexalobular socket heads (ISO
10664). Installation requires the use of matching tools.
1

IP55, IK07, Class I, ta= 40°C
Wall Luminaire Surface Mounted
FLC122
FLC142
2

Installation Procedure
1) Switch off and isolate mains electrical supply. 2) Remove mounting flange A by loosening
screws B. Detach terminal connectorC.
3) Check that rating shown on luminaire label
conforms with mains electrical supply.
12/17IP55
FLC122-LED 220-240V50-60/Hz
145-XXXX SOEXXXXXXX
LED 3000K 12W item no. XXX
(example)
4) Determine position for fixing screws D. Drill
relevant holes E and insert nylon plugs F.
Warning: Ensure not to damage anyelectrical
cable, water pipe or other items drillingholes.
3

5) Feed mains supply cable G (and second cable
H for through wiring, if required, FLC142
ONLY) through membrane spout(s) I(for
diameters 1-9mm), while setting mounting
flange A inposition.
6) Luminaire is also supplied with accessories to
suit a variety of cable types. Unscrew
membrane sprout(s) Iand place packing ring L
(for cable diameters 7-9.5mm) or packing ring
M(for TPS cable), depending on cable type.
Thread cable Gthrough, and screw down
pressure screw N.
7) To fix mounting flange A, pierce through nylon
plugs J by inserting and tightening screws D.
Attention: Nylon plugs J must remain in
position to providesealing.
8) Connect mains supply cable G leads to
respective terminals in terminal connector K:
a) ON/OFF (L = Phase, N =Neutral,
=Earthing)
b) 1-10 V/DALI (L = Phase, N = Neutral,
= Earthing, DA/DA = DALI control line,
D–/D+ = 1-10 V controlline).
4
I
LM
NG

9) Ensure that all surfaces are clean and dry.
Position luminaire over mounting flange A
and attach terminal connector C. Tighten
screwsB.
5

www.we-ef.com
WE-EF LEUCHTEN
Germany
Tel [phone]
Fax [phone]
[e-mail]
WE-EF LUMIERE
France
Tel[phone]
Fax [phone]
[e-mail]
WE-EF HELVETICA
Switzerland
Tel[phone]
Fax [phone]
[e-mail]
WE-EF LIGHTING
UnitedKingdom
Tel [phone]
Fax [phone]
[e-mail]
WE-EF LIGHTING
Thailand
Tel [phone]
Fax [phone]
[e-mail]
WE-EF LIGHTING
Australia
Tel [phone]
Fax [phone]
[e-mail]
WE-EF LIGHTING
United States of America
Tel [phone]
Fax [phone]
[e-mail]
TO9205W0519 © WE-EF 2019
Technical specifications are
subject tochange.