Wren FEATURE CHEST 1 User manual

For Internal Use: FI.PK.BED.222.016_WBIN00039_FeatureChest1_FittingGuide_Rev1 Page 1
CHEST UNIT
Feature Open Chest & Storage Unit Fitting Guide
FEATURE CHEST 1 - FI.PK.BED.222.016
Screws and fixings for attaching to walls and chest tops are not provided as
these vary depending on materials, thickness and construction.
Ensure appropriate fixings are used.
(K) x8
30mm
Screw
(L) x18
15mm
Screw
Step1.
Place the unit on its side. Secure each of the legs in place with 2 x 15mm
screws (L) per leg.
Ensure legs are rotated as shown so the tab is supporting the end panel.
Attach bottom section of legs and set all legs to the same height.
2x Corner Gusset Plate

For Internal Use: FI.PK.BED.222.016_WBIN00039_FeatureChest1_FittingGuide_Rev1 Page 2
CHEST UNIT
Feature Open Chest & Storage Unit Fitting Guide
FEATURE CHEST 1 - FI.PK.BED.222.016
Step2.
Position the unit and level using an 8mm hex key from inside the unit.
Step 5.
Screw into any side units using the 30mm screws (K) provided to secure to the
unit. Screw at the top and bottom on both sides of the unit.
Step 6.
Screw up through the top xed shelf into the chest top using 30mm screws (K)
provided to secure it in place.
Step 4.
Secure the unit to the wall by screwing through the pilot hole and gusset from
step 3 into the wall.
Step 3.
Secure corner gusset plates to the top left and right side
on the back of the unit, using 4 x 15mm screws (L) per
plate. Drill a pilot hole through the centre of the corner
gusset plate.
Inside View