Wren UNDER ROBE 1 Assembly instructions

For Internal Use: FI.PK.BED.222.015_WBIN00033_UnderRobe1_Rev1
ROBE UNIT
Under Robe Fitting Guide
UNDER ROBE 1 - FI.PK.BED.222.015
Step 1.
Position top section of legs as shown. Ensure legs are rotated to provide support to the
end panels. Secure with 2 x 15mm screws per leg.
Attach bottom section of legs and set all legs to the same height.
400 - 500 Widths: 4 Legs
800 - 1000 Widths: 5 Legs
Step 2.
Lift the unit upright. Once in situ level accordingly, using an 8mm hex key from inside the unit.
6 x 30mm Screw
500 Width used for illustrative purposes only

For Internal Use: FI.PK.BED.222.015_WBIN00033_UnderRobe1_Rev1 For Internal Use: FI.PK.BED.222.015_WBIN00033_UnderRobe1_Rev1
ROBE UNIT
Under Robe Fitting Guide
UNDER ROBE 1 - FI.PK.BED.222.015
Step 3.
Position the robe on top of the under robe, ensure the front and sides are aligned with each other. Using
the 30mm screws provided, screw down through the robe bottom xed shelf into the under robe top xed
shelf to secure the units together. Cover screw heads with cover stickers provided to conceal them.
Alternative front screw location.
Using an angled drill attachment, the front screws only, can be
secured from the underside by screwing up through the top xed
shelf of the under robe into the bottom xed shelf of the robe unit.