Yealink T20P User manual

User Guide – Yealink T20P
http://www.virtualglobalphone.com Dec - 2014
Is a entry level IP Phone with high-definition audio, a broad range of voice codec’s support. Its easy
to install and inexpensive from to start up for both enterprise and residential users.
YealinkT20P
These instructions are based on using the T20 in its factory default configuration, which obtains a
dynamic IP address automatically from your router using DHCP. For information on configuring your
T20 with a static IP address please refer to the T20 user manual.
For the purpose of this guide we will use the LCD Configuration and web interface to add an account.
The guide also assumes that you have connected the device to a proper power source, Ethernet
cable is connected from the device to switch / router and its obtained a LAN / WAN IP Address. If not
please check with your provider or system administrator and then proceed to below steps.
LCD Configuration
STEP 1 Click on the ‘Menu’ button
STEP 2 Choose “Settings” > “Advanced”
STEP 3 Enter your admin password, the default password is “admin”

User Guide – Yealink T20P
http://www.virtualglobalphone.com Dec - 2014
STEP 4
Choose which line to configure among line 1 and 2.
STEP 5
Enter the following information
Label: <VirtualGlobalPhone>
Display name: (anything you want, can be your VirtualGlobalPhone number)
Register name: <sip username>*
Username: <sip username> *
Password: <sip password> *
Sip server: sip.virtualglobalphone.com
Outbound: enable (if you want to make outgoing call)
Outbound host: sip.virtualglobalphone.com
STUN: disable
Auto answer: disable
* Use your username and password provided by VirtualGlobalPhone.
STEP 6
Press “OK” and wait a few seconds for your IP phone to be “Registered”.
**To make outgoing calls, follow this standard: <country code> + <area code> + <destination>.
For example, if you are calling a Hong Kong number 12345678, key in: 85212345678 and call.
Web Configuration
STEP 1
On your device, click on Menu and go to "1. Status" to check the IP address
.
STEP 2
Open a web browser and type your IP address
in the address bar.
STEP 3
Type in the Username and Password. The default is "admin" for both Username and Password
STEP 4
Once you log in, click on "Account" on the top.

User Guide – Yealink T20P
http://www.virtualglobalphone.com Dec - 2014
STEP 5
Enter the following information:
Line Active: Enabled
Label: Anything you like to appear on the LCD of your phone
Register Name: SIP account we provide (e.g. yealink12 / 0891112345)
User Name: SIP account we provide (same as Register Name)
Password: SIP password we provide
Server Host: sip.virtualglobalphone.com
STEP 6
Click on "Confirm" and your phone will be configured.
**To make outgoing calls, follow this standard: <country code> + <area code> + <destination>.
For example, if you are calling a Hong Kong number 12345678, key in: 85212345678 and call.