ZKTeco X6 Instruction sheet

X6 CONFIGURATION MANUAL

Default Program Password : 1234 maximum finger : 500
CREATE ADMIN

exit (green light on and a long buzz)
CHANGE ADMIN


FORGOT ADMINISTRATOR PASSWORD
If the administrator password is lost, you can reset the password to default by using tamper switch.
Operation:
1. Dismantle the device and wait for 30 seconds until a short beep is heard.
2. Press the Tamper Switch thrice to reset to the initial administrator password.
This operation must be done within 30 seconds; the default administrator password is 1234.
ADD/EDITUSER (finger)
Each user can resist 10 fingerprint and 1 card at most
Px) 
continue to add new users OR press [*] to escape(green light on
and a long buzz)
ADD CARD
Pmax)  card 2 times

long buzz)
ADD PASSWORD
The machine support at most 8groups of door password,
-

Note:
A. When a group of password was changed into 00000, then this group of password was shut down
B. When a group of password was changed successfully, you can input next group of number to modify
directly.
OPEN DOOR BY PASSWORD
Enter password and press # for verification

DELETE SINGLE USER

fingDelete all of the users
DELETE ALL USER

DOOR UNLOCK DURATION
Default: 6 second

CONFIGURE ATHENTICATION MODE (FP/PW/RF)

Mode
Value
Description
PW
1
Only Password
RF
2
Only Card
FP
3
Only fingerprint
FP/PW/RF
4
Fingerprint or password or card
RF& PW
5
Card then password
FP & PW
6
Fingerprint them password
CONFIGURE ALARM
Alarm Switch (Default ON) The switch is the master switch of the machine, only when it's on, can the alarm
incorrectly, tamper alarm and magnet alarm be working properly. The alarm will be shut down when it's


TAMPER ALARM CONFIGURE (Default ON)


Buttons represent: [#] means yes, [*] means Escape
Lights represent: Green means success, Red means Failure
Number: Password=4 digits, work code<=5 digits
Tones: Long buzz means success, short buzz twice means failure, short buzz 4 times means
wrong action Notice: make sure you pressed [#] to confirm, [*] exit