9A
Software version
Press the MENU button up to when the is blinking on the display. Pressing ENTER
button and the display will show the version of software of the unit. To go back to the
functions press the MENU button again.
5. How to control the fixture
There are three ways to control the fixture
A. Universal DMX controller
B. Master/Slave operation
C. Easy controller (by CA-8)
A. Universal DMX controller
The fixture can be set the DMX address remotely by universal DMX controller. First, you
need to programming two scenes into a chase, and then link the fixtures to the universal
DMX controller. When you run the chase, all the fixtures of the chain will be set the series
DMX address automatically. The fixture uses four channels. Please refer to the following
diagram to set the address for the first four units.
B. Master/Slave operation
The fixture will allow you to link 16 fixtures together and operate without a controller. In
Master/Slave mode, the first fixture will control the others to give an automatic, sound
activated, synchronized light show. This function is good when you want an instant show.
The first fixture it’s DMX input cable will have nothing connect it, and the other fixtures will
be set in slave mode automatically. Their DMX input cables connect the last fixture DMX
output cable (daisy chain). Any fixture can act as a Master or as a Slave
6A
DMX 512 Address Setting
Press the MENU button up to when the is shown on the display. Press ENTER
button and the display will blink. Use DOWN and UP button to change the DMX512 address
or select (auto setting) mode. Once select, press the ENTER button to store or
automatically return to the main functions without any change after 8 seconds. To go back to
the functions without any change press the MENU button again.
Channel mode
Press the MENU button up to when the is shown on the display. Pressing ENTER
button and the display will blink. Use DOWN and UP button to select the (channel 1)
or (channel 2) or (channel 3) or (channel 4) mode. Once the mode
has been selected, press the ENTER button to setup or automatically return to the main
functions without any change after 8 seconds. To go back to the functions without any
change press the MENU button again.
ShowMode
Press the MENU button up to when the is shown on the display. Pressing ENTER
button and the display will blink. Use DOWN and UP button to select the (auto
show) or (show 1) or (show 2) or … (show 12). Once the show
has been selected, press the ENTER button to confirm, if you select (show 1) or
(show 2) or … (show 12), you can press DOWN and UP button to select
(slowest) or …(fastest), press ENTER button to store or automatically
return to the main functions without any change after 8 seconds. To go back to the functions
without any change press the MENU button again.
Chase Mode
Press the MENU button up to when the is shown on the display. Pressing ENTER
button and the display will blink. Use DOWN and UP button to select the (chase 1)
or … or (chase 16) or (fade). Once the chase has been selected, press
the ENTER button to confirm, then press DOWN and UP button to select (slowest)