ACS ALERT J4X User manual

QG-ENG-AU-60-000763-A
© 2015 Quick guide
© 2015 Alcohol Countermeasure Systems
ACS, ALCOHOL COUNTERMEASURE SYSTEMS,
ALERT and "The Molly" are trademarks of Alcohol
Countermeasure Systems (International) Inc. and are
used under license.
The ALERT J4X personal breath alcohol
tester has met the requirements of
EN55011 and EN61326-1.
Under the ACMA regulations for EMC
requirements, the ALERT J4X personal
breath alcohol tester has been classied
as a low-risk device, since it is only
powered through a battery.

TAKING A BREATH TEST
1. Insert a new mouthpiece into the ALERT J4X
tester. To ensure accurate results, use a new
mouthpiece every time.
2. Power on the tester by pressing the button.
Wait for the READY icon to appear.
3. Blow steadily and continuously into the
mouthpiece. A continuous tone will sound
and the port will glow green to indicate proper
breath ow.
4. Stop blowing only when the tone ends. A click
sound is heard, but continue blowing.
5. The tester analyzes the breath sample and
displays BrAC results in a few seconds.
6. The tester powers down after a period of
inactivity. To power down manually: press the
button twice, quickly.
REPLACING BATTERY
The tester requires 2 AA alkaline or rechargeable
batteries to operate. To insert, turn the tester off
and remove the back cover by pressing down on
the indent and sliding the cover back.
ENG
The ALERT J4X breath alcohol tester is easy to
use. It measures the alcohol content of the breath
(BrAC), which is in direct proportion to the alcohol
concentration of the blood (BAC). The readout is
provided with digital display. The tester has only
one button, making it very easy to operate.
SAFETY & PRECAUTIONS
• Before testing: Wait 20 minutes after drinking or
eating and 3 minutes after smoking
• Use the tester within the ambient temperature
range of -5 to 40°C (23to122°F)
• For ambient temperatures lower than -5 °C
(23°F), use the optional car adaptor
• Use this tester for its intended purpose only
ICONS:
Wait
Ready: Take a breath sample
Error: Refer to the instruction manual
for troubleshooting steps
Abort: Breath sample incomplete
Ambient temperature between -5to
15°C (23 to 59°F)
Auxiliary power: When ambient
temperature is below -5°C (23 °F)
icon will ash and connection with
car adaptor is recommended; below
-5(23°F), connection is mandatory;
icon will be solid once connected
Battery strength indicator: When
blinking, the batteries need to be
replaced
FEDERAL COMMUNICATIONS
COMMISSION (FCC) DISCLAIMER
Changes or modications not expressly approved
by the party responsible for compliance could void
the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC
rules. Operations are subject to the following 2
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference
received, including interference that may cause
undesired operations.
INDUSTRY CANADA
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference,
including interference that may cause undesired
operation of the device.
EN 15964
Manufactured by:
Alcohol Countermeasure Systems Corp
60 International Boulevard
Toronto, Ontario M9W 6J2 CANADA
[email protected]
acs-corp.com