Argos AVR 4 Seater Patio Set User manual

Dimensions
Diameter - 80cm
Height -70cm
Issue 1 - 26/05/10
Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400 800
Assembly Instructions - Please keep for future reference
AVR 4 Seater Patio Set - Table
651/1555
Important –

This product is
manufactured from
toughened safety glass.
In the unlikely event that
the glass fails it will break
in to a large number of
small fragments that may
be spread over a wide
area. This is a feature of
toughened glass,
designed to remove the
risk of injure from glass
breaking into large shards.
If the glass is chipped
or broken, stop using the
product and consult the
manufacture or supplier.
Check you have all the
components and tools
listed on page 2.
Remove all fittings from
the plastic bags and
separate them into their
groups.
Keep children and
animals away from the
work area, small parts
could choke if swallowed.
Make sure you have
enough space to layout
the parts before starting.
Do not stand or put
weight on the parts during
assembly, this could
cause damage.
Assemble on a soft
level surface to avoid
damaging the unit or your
floor.
Dispose of all packing
carefully and responsibly.
Do not sit or stand upon
horizontal glass surface.
Do not place very hot or
very cold items on the
glass unless adequately
thick tablemats are used to
prevent such items from
coming into contact with
the glass.
The unit
weights approximately
kgs.
Warning:
Please lift with care.
Wash frame parts with
mild soap and water, rinse
thoroughly, and dry frame
completely. Do not use
bleach, acid, or other
solvents on the frame
parts.
Wash glass with mild
soap and water, rinse
thoroughly, and dry glass
completely.
When moving the table,
remove the umbrella. Do
not drag.
We recommend the use
of furniture covers when
not in use.
Do not use the glass as
chopping surface. Do not
strike the glass with hard
or pointed items.
In order to prolong the
life and beauty of your
table, we recomm end it be
stored in a dry and
protected area during off
season periods.
Do not use washing
powders or any abrasive
substances which may
scratch the surface.
10

Components - Parts
Please check you have all the parts listed below
2
Table leg x 4
Table top x 1
1
3
Center connector x 2
Note:
The quantities below are the correct amount to complete the assembly.
A
Screw cap x 8
B
Metal washer x 8
C
DE
Allenkey x 1
45mm Screw x 8
Please check you have all the fittings listed below
Components - Fittings
(Have already fixed on the leg tube)
Plastic support x 4
2
Ruler - Use this ruler to help correctly identify the screws
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 110 115 120 125 130 135 140 145 150 155 160 165 170
105

Assembly Instructions
Step 1
Assembly frame
Step 2
Important:
Do not fully
tighten all screws
until assembly is
complete.
C
A
1
2
Place the table top 1 on
a non-abrasive surface,
such as carpet ,with the
underside facing up. Insert
the legs 2 into the plastic
holders attached on the
back of the table top
rim 1 .
Mount and align the center
connector 3 to the middle
of the legs 2 , then fasten
them by using washers
and screws .
A
C
3
E
Important:
Make sure the
plastic support
not detached from
leg tube.
E
2
2
3
2
1
Suggest to complete this
product assembly by two
person.
3
1

Assembly Instructions
4
Step 3
Step 4
2
3
2
1
3
C
A
B
Repeat step 2 to install the
center connector 3 .
Tighten all the screws
and seal them with
caps .
A
B
If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400800
Argos Limited
489-499 Avebury Boulevard Saxon Gate West Central Milton Keynes Bucks,MK9 2NW
Assembly is complete.
cap
Turn the table top 1 to
its upright position and
please remove the cap if
you want to insert parasol.
Warning:
The parasol must be
placed into the parasol's
base if the table set need
to match a parasol.