Arjo Maxi Sky 1000 User manual

Hand control
Enhanced Charging System (ECS) rail system
This rail system allows continuous charging wherever it is on the track. It eliminates the need to send the unit
back to the charging station after the patient transfer.
Overheat protection device
When the lift exceeds its duty cycle, a detection system blocks the lifting of a load until the temperature of the
transmission cools down. It is still possible to activate the horizontal displacement and down functions. The red
light stays on during the cooling period and a buzzer will sound if the UP button is pressed. The cooling period is
between 10 to 30 minutes depending on ambient conditions.
Return to charge (RTC)
Press on the RTC button for 3 seconds.
The spreader bar will raise all the way up to avoid any obstacles during the run. When the lift is at the charging
station, the spreader bar lowers to the preselected height to be easily accessible.
The RTC function is not an automatic transfer function. A safety weight detector is included in the device to
prevent the use of the function when a patient is present in a sling.
Power light - green
Flashing Low batteries
Solid The lift is on and ready to use
Charging light - amber
Flashing Charging batteries
Solid Batteries charged
Maintenance/overheat light - red
Flashing Maintenance required by your local agent
Solid Lift powered up in “service mode”, “progamming mode” or overheat protection state.
Indicator lights - on lift
Up button
Down button
Right button
Left button
Return to charge button
Programming mode button
001-14745-EN Rev 0 • 06/2020 • Page 1/3
Maxi Sky 1000
QUICK REFERENCE GUIDE - FUNCTIONS

12
Emergency stop (red cord)
Emergency brake
Pull the red emergency cord until a “click” is
heard.
The reset switch’s plastic insert, at the top of
the red cord, has descended. The green power
light is turned off. The patient begins to descend
slowly when the emergency stop is activated,
this is normal.
To reactivate the lift, push up on the reset
switch’s plastic insert. The green light is turned
on and the lift is ready for use.
The emergency brake is an additional safety feature that automatically prevents the patient from
falling in the unlikely event of a transmission or motor failure.
The emergency brake is intended for single activation and therefore can only be used once. Call
your Arjo agent to arrange for the unit to be replaced. The emergency lowering device cannot be
used when the emergency brake has deployed.
Spreader bar and scale attachment or removal (Basic ceiling lifter model only)
Insert the strap end onto the spreader bar attachment.
Insert the clevis pin through the attachment and the loop at the
end of the strap. Secure the clevis pin with the split ring.
12
001-14745-EN Rev 0 • 06/2020 • Page 2/3

12
Emergency lowering
The emergency lowering mechanism provides a
safe way of getting the patient down onto a
chair, bed or wheelchair. Only used in case of
an emergency if an electrical failure occurs.
Pull the red emergency cord.
Remove the black cap located on each side at
the top of the lift.
3
Insert the 8 mm Allen key that came with the
ceiling lift into the axle.
Turn the Allen key counter-clockwise to slowly
lower the patient. Repeat on the other side of
the lift if required.
001-14745-EN Rev 0 • 06/2020 • Page 3/3
ArjoHuntleigh AB
Hans Michelsensgatan 10
211 20 Malmö, Sweden
www.arjo.com