Assa Abloy EMTEK Tubular Monolithic Entry Set User manual

1. Door Prep 2. Door Jamb Prep
Installation Guide - Tubular Monolithic Entry Set - Single Cylinder Deadbolts
4. Outside Installation
Extension Collar is provided for thin doors.
5. Inside Installation
IN4-ENTSETSGMON 04-29-2013
2-1/4"
5-1/2"
2-3/8"
or
2-3/4"
1/8"
Deep
2-1/4"
1"
1" Dia.
Edge Bores
2-1/8" Dia.
Bores
3/16”
Deep
2-3/4”
1-1/8”
1-1/4”
1/8”
Deep
After lock is
installed, tighten
set screw with
hex wrench
provided.
Plates and grips vary depending on style.
* Marretta 6 style locks have 6” center to center
bore spacing.
*
Install with tail piece
horizontal
Optional extension
collar for thin doors

Optional Dead
Bolt Collar
For Brass Only
Optional Dead
Bolt Collar
For Brass Only
2-1/8" Dia.
Bores
2-3/8"
or
2-3/4"
5-1/2"*
2-1/8" Dia.
Bores
2-3/8"
or
2-3/4"
No less
than
4-1/2"
Installation Instructions-Tubular Monolithic Entry Set - Dummy
*Marietta 6 style locks have 6” center
to center bore spacing.
Installation Instructions-Tubular Sectional Entry Set - Dummy
IN4-ENTSETDUMY REV. 03/26/08
IMPORTANT:
Do not remove screws
AFTER LOCK HAS BEEN INSTALLED
Tighten Set Screws with Allen Wrench
AFTER LOCK HAS BEEN INSTALLED
Tighten Set Screws with Allen Wrench