Assa Abloy Lockwood 8816 User manual

*
*
Mejsel pozidrive
1
2
1)
FIT BATTERIES
3)
1) Remove the battery closure cap using the tools supplied.
2) Insert batteries in the appropriate polarity as shown.
3) Firmly secure the battery closure cap back into position.
*Refer to the ‘Operating Instructions’ on page 3 for more information about battery use and replacement.
2)
A
B
C
A
B
C
12A) Slide latch into hole and mark around latch
face plate.
B) Chisel out face plate recess to appropriate
depth.
C) Insert latch with angled face of bolt towards
door jamb and fasten with the 2 screws
provided.
NOTE: When completed make sure holes
are free of any sawdust or loose material.
Ensure your door fulfils the above
minimum requirements.
backset
32 - 45 mm
door thickness
latch recess
preparation
DOOR PREPARATION
1
8816 CODE HANDLE
FITTING INSTRUCTIONS
SUPPLIES
Tape measure or Ruler Pencil
54mm
Hole Saw
Power Drill
Screw Drivers 25mm
Spade Bit
25mm Chisel
+
+-
-
A
C

90°
5
2
5)
Outer Handle Inner Handle
1
2
3)
4)
4
1) 2)
FIT HANDLES
IMPORTANT NOTE:
If the administrator’s code is changed, all user codes will be erased.
It is important to write your administrator’s code on page 3 and store it safely.
To change the administrator’s code, repeat this procedure.
An administrator’s code must be initiated prior to fitting the handle.
1) Hold the handle horizontally with the square shaft facing downwards, as shown on the illustration above.
2) Press buttons 1 and 4 at the same time.
The LED flashes red rapidly. Release buttons.
The LED lights steady green.
3) Enter a 6 digit administrator’s code.
The LED flashes green rapidly.
The entered administrator’s code is now activated.
enter a 6 digit
administrator’s code : ### ###
3)
2)
press 1 & 4
at the same time
square shaft
facing downwards
8816 CODE HANDLE
FITTING INSTRUCTIONS
3REGISTER AN ADMINISTRATOR’S CODE
1)
6TEST TO UNLOCK & LOCK
SET USER CODES

USER CODES
8816 CODE HANDLE
OPERATING INSTRUCTIONS
BATTERIES
The 8816 Code Handle is delivered with two CR2 batteries.
SECURITY

ASSA ABLOY Australia Pty Limited, 235 Huntingdale Rd, Oakleigh, VIC 3166 ABN 90 086 451 907 ©2013
The global leader in door opening solutions
4
AUTOMATIC LOCKING
AUDIO SIGNALS
8816 CODE HANDLE
OPERATING INSTRUCTIONS
SECURITY
RESETTING THE CODE MEMORY
GENERAL SAFETY PRECAUTIONS
SECURITY
P