Ballard Designs Ashcroft MQ121 User manual

Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 12-21-2020 Page 1 of 3
PRODUCT NAME: Ashcroft Media Console
ITEM NUMBER: MQ121
ASSEMBLED DIMENSIONS : 36”H x 62.5”W x 17.5”D
MADE IN INDONESIA
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 3
Ltr.
A2
Qty. Hardware Included
Ltr.
B 1
Qty. Components
REQUIRED TOOLS:
Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
ANCHORING HARDWARE INCLUDED
Console (B)
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Wall Anchoring
Anti-tip Kits
See Page 3
LEVELERS: Nightstand is equipped with Rotary Levelers installed under each leg. If necessary, adjust-
ments may be made by carefully lifting applicable corner and turning Leveler clockwise/counterclockwise.
Shelf
Screwdriver
Screw
Hole
Shelf Supports
SHELVES: Adjust Shelves by removing Set Screws from underside and removing Shelf from Supports.
Reposition Supports, replace shelf then reinsert and tighten Set Screws.
Cleaning and Care
Periodically dust with a soft, dry cloth.
Protect surfaces to prevent damage.
Do not use alchohol based cleaners or polishers.
LEVELER
Assemble in location for intended use.

Page 3 of 3
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Installation:
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
WALL ANCHORING HARDWARE (ANTI-TIP)
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
WALL BRACKET MUST BE ATTACHED TO WALL STUD
WALL STUD
(C)
(B)
(D)
(A)