Ballard Designs Original Home Office MO315 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 8-14-2020 Page 1 of 4
PRODUCT NAME: Original Home Office™ Craft Height Shelf
ITEM NUMBER: MO315
ASSEMBLED DIMENSIONS : 37 1/4”H x 37 1/2”W x 12”D
IMPORTED
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 4
Ltr.
A 8
B2
Qty. Hardware Included
Ltr.
E
F
1
2
Qty. Components
C12
REQUIRED TOOLS:
Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
D2
Shelf Supports
Connector Brackets
Screws
Wall Anchoring
(Anti-Tip) Kits
See page 4
Case (E)
Shelves (F)
WARNING
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
ANCHORING HARDWARE INCLUDED
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Assemble in location for intended use.

Page 3 of 4
STEP 1: Determine location for each Shelf (F) then insert Shelf Supports (A) into corresponding
pre-drilled hole. Lay Shelf level upon Supprts.
(A)
(F)
STEP 2: (OPTIONAL) Place Top (sold separately) upon two Craft Height Shelves then use Connector
Brackets (B) with Screws (C) to secure in place. See illustration below:
(C)
(B)
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 3 of 3
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Installation:
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
WALL ANCHORING HARDWARE (ANTI-TIP)
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
W
A
L
L
S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(A)
(B)
(C)
(D)