Ballard Designs SK075 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 3/18/2019 Page 1 of 5
PRODUCT NAME: Fairmont Kitchen Pantry
ITEM NUMBER: SK075
ASSEMBLED DIMENSIONS : 77”H x 45 3/4”W x 23 7/8”D
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 5
Ltr.
D 3
Qty. Components
TOOLS NEEDED:
-Phillips Screwdriver, Drill
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
Shelf
Ltr.
A 16
B 12
Qty. Hardware Included
C 2
Screw
Shelf Support
L-Bracket*
*IMPORTANT:
To insure safety, Pantry MUST be secured to a Wall Stud using L-Bracket (C) before use.
Hardware (A-C) Shelves (D)
Assemble Pantry in desired location for use.

B
D
Assemble Pantry in desired location for use.
Page 3 of 5
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1: Determine Shelf (D) placement and insert Shelf Supports (B) into corresponding pre-drilled
holes. Gently lay and fit Shelf into place by resting each on a Shelf Support.
Pantry is equipped with Levelers on all four corners at the base. If needed, turn
leveler clockwise/counterclockwise to adjust to level. NOTE: If necessary, align doors
by adjusting levelers.
STEP 2:

Assemble Pantry in desired location for use.
*IMPORTANT:
To insure safety, Pantry MUST
be secured to a Wall Stud
using L-Bracket (C) before use.
Page 4 of 5
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 3: Center the Pantry in front of two wall studs and mark the wall. Push Pantry against the wall.
Note: Wall Studs are typically 16” apart (center to center).
Slide L-Bracket (C) over top corner of Pantry and align (as shown below) with previously
marked stud locations on wall. Using a pencil, mark the wall at the TOP of the L-Bracket.
NOTE: To insure the bracket is hidden, it must be positioned as shown.
STEP 4:
WALL
STUD
STUD
C
Mark Here
STUD

Assemble Pantry in desired location for use.
Page 5 of 5
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as finish damage may result.
Dust with a soft cloth.
STEP 5: Pull Pantry away from wall, then firmly secure L-Brackets (C) to wall studs using
Screws (A).
A
C
STEP 6: Gently slide the Pantry under previously installed Brackets (C) and use 2 or more remaining
Screws (A) to firmly secure L-Brackets to Pantry top.
NOTE: Due to wall or floor molding, the Pantry may not be permitted to move far enough back to com-
pletely go under each bracket. In this case, use screws only in holes that completely cover Pantry top.
A
C