Ballard Designs Bunny Williams Milton MV460 User manual

Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 1-6-2021 Page 1 of 4
PRODUCT NAME: BW Milton Bookcase
ITEM NUMBER: MV460
ASSEMBLED DIMENSIONS : 90”H x 46”W x 17”D
MADE IN INDIA
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 3
Ltr.
A2
B12
Qty. Hardware Included
Ltr.
C1
Qty. Components
REQUIRED TOOLS:
Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
ANCHORING HARDWARE INCLUDED
LEVELERS: Bookcase is equipped with Rotary Levelers installed under each corner. If necessary,
Bookcase may be ajusted by carefully tipping applicable corner and turning Levelers clockwise/counter-
clockwise.
Assemble in location for intended use.
Anchoring/Anti-Tip
Screws
(Page 3)
Anchoring/Anti-Tip
L - Brackets
(Page 3)
Bookcase (C)
Cleaning and Care
Periodically dust with a soft, dry cloth.
Protect surfaces to prevent damage.
Do not use alchohol based cleaners or polishers.

Page 3 of 3
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1: Determine installation location, then identify two *wall studs behind Bookcase (C). Push Book-
case into place then slide each L-Bracket (A) over top of unit and center in front of each *wall stud. Use
pencil to mark wall at top of each Bracket.
IMPORTANT: Orient Brackets as illustrated to ensure they are not visible after installation.
(C)
(A)
(B)
Wall Studs
*Brackets MUST be anchored to a wall stud.
Pencil mark here
(A)
WALL
STUD
STEP 2: Pull Bookcase away from wall, align L-Brackets (A) with marks on wall then anchor L-Bracket
directly into wall stud using four Screws (B).
STEP 3: Move Bookcase back into place and slide under both L-Brackets (A). Attach using Screws (B)
and a Phillips Screwdriver to firmly tighten. NOTE: Floor molding may prevent all holes from covering
top, install Screws those holes which cover top.
Wall Stud
(A)
(B)