Ballard Designs MO331 User manual

Screws
PRODUCT NAME: Bouclier Desk
ITEM NUMBER: MO331
DIMENSIONS OF ITEM ASSEMBLED:
30”H X 56”W X 26”D
This item is not intended for commercial use.
Made in Italy.
Page 1 of 2
2010 Ballard Designs, Inc.
Check to ensure that you have the following:
Hardware Included
.ytQ.rtL
A 8
Part List
.ytQ.rtL
B 4Legs
800.367.2810
www.ballarddesigns.com
For Assembly Purposes:
-Requires 2 people.
-Be careful of the legs.
-Requires a screwdriver.

800.367.2810
www.ballarddesigns.com
STEP 1: Leg Installation
Page 2 of 2
2010 Ballard Designs, Inc.
Remove the drawers and flip desk on its top. Install all 4 Legs (B) by sliding the
legs into the grooves in the corners of the desk. Be sure the dowel on the top of each leg
locks into the hole in the desk.
(B)
STEP 2: Leg Installation Part 2
Attach each Leg (B) using two Screws (A) in the pre drilled holes on the inside
edge of the desk.
(B)
(A)
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as they can damage the finish.
Dust with soft cloth. One to two times monthly apply beeswax polish as needed.
Finish can be affected by heat or extended contact with oils or wine.