Ballard Designs Villandry MB511 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 9-29-2020 Page 1 of 4
PRODUCT NAME: Villandry Bed
ITEM NUMBER: MB511
ASSEMBLED DIMENSIONS : KING - 57”H x 81 1/2”W x 85 1/4”L
QUEEN - 57”H x 65 1/2”W x 85 1/4”L
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN INDONESIA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 4
Ltr.
A 8
B8
Qty. Hardware Included
Ltr.
5
4
1
1
Qty. Components
C 8
TOOLS NEEDED:
Wrench (included), Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
J
I
K
H
G
2
E
F 1
10
Threaded Studs
Half-Moon
Washers
Lock
Washers
Screws
Wrench
Headboard (G)
Footboard (H)
Side Rail (I)
Support Slat (J) Support Foot (K)
Assemble in location for intended use.
D 8 Hex Nuts

Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1: ATTACH SIDE RAILS TO HEADBOARD AND FOOTBOARD
Insert and tighten Studs (A) into both sides of Headboard (G). Align holes in Side Rails (I) over ends of
Studs then add Half-Moon Washer (B) followed by Lock Washer (C) then Hex Nut (D). Using Wrench (F),
firmly tighten Nuts until Side Rails are secured to Headboard. Repeat process for Footboard.
STEP 2: ATTACH A SUPPORT FOOT TO EACH SUPPORT SLAT
Remove protective plastic covering from each Stud on Support Foot (K) then insert each into pre-drilled
holes in each Support Slat (J). One Slat DOES NOT have a Support Foot. Place nearest Footboard.
NOTE: Metal T-nut faces up. Insert Support Foot from the side opposite the T-nut. Firmly tighten
and secure.
T-nut in Support Slat faces
up.
NOTE
(K)
(J)
(A)
(G)
(B)
(C) (D)
NOTE: There are 5 Slats. Place Support Foot onto
4 and place the Slat without a Support Foot closest to
Footboard so it will not be visible after assembly.

Page 4 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Cleaning & Care:
DO NOT use alcohol based products or spray polisher as finish damage may result.
Dust with a soft cloth.
STEP 3: ATTACH SUPPORT SLATS TO SIDE RAILS
Evenly space Support Slats (J) with ends on the ledge of the Side Rails (I). Use Screws (E) to firmly
secure each into place. NOTE: Slat without a Foot Support is placed nearest the Footboard to
ensure Support Foot is not visible after Bed is fully assembled.
STEP 4: ADJUST LEVELERS
If necessary, each Support Slat may be leveled by adjusting Leveler located under each Support Foot (J).
Carefully raise off floor and turn clockwise/counterclockwise to adjust.
(E)
(J)
(I)
(J)