Ballard Designs SL203 User manual

Ltr.
G
Qty. Components
F4
Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
Legs (H)
Ltr. Qty. Hardware Included
*Connector Plates
Allen Bolts
(5/16” x 2”)
Allen Wrench
(M5)
Flat Washers
Top (G)
1
Cleaning and Care
Avoid harsh or abrasive chemicals as finish damage may result.
Use coasters, trivets, placemats to protect surfaces.
Promptly remove spills. Dust with a soft, dry cloth.
REQUIRED TOOLS:
Allen Key (included)
- Two person assembly suggested.
A8
B8
C8
D1
E2
H4
Lock Washers
*Wood Screws
(8mm)
*used when joining Millstone Table to **Millstone Kitchen Island.
**Millstone Kitchen Island (SK110) SOLD SEPARATELY
Hardware Packet and Legs ship inside table.
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 11-29-2022 Page 1 of 2
PRODUCT NAME: Millstone Counter Height Table
ITEM NUMBER: SL203
ASSEMBLED DIMENSIONS : 37 1/4”H x 48”W x 30”D
MADE IN VIETNAM
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 2
STEP 1: Invert Top (G) onto a level padded surface. Align holes in each Leg then insert Allen Bolt (C) with
Lock Washer (B) and Flat Washer (A). Tigthen using Allen Wrench (D)
Assemble in location for intended use.
STEP 2: Table equipped with Rotary Levelers installed under each Leg. If necessary, Table may be
adjusted by carefully lifting applicable corner and turning Leveler clockwise/counterclockwise.
12
CAUTION
Remove Connector Plates and
Scews BEFORE moving assembled
Table/Island.
Plates/Screws may be permanently
damaged.
(B)
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(A)
(C)
(H)
(D)
(G)
(H)
(H)
(H)
OPTIONAL: Connecting Millstone Kitchen Island (SK110) to Millstone Counter Height Table (SL203)
STEP 1: Follow Assembly Instructions for Table and fully assemble before proceeding.
NOTE: Assemble Table in area with Kitchen Island.
STEP 2: Place Kitchen Island in location for use. Slide assembled Table against one end and align
edges. NOTE: Levelers may need adjustment in order to align Table/Island Surfaces.
STEP 3: With Table and Island aligned and completely pushed together, place Connector Plates (E)
over seams between the two on both outer edges. Insert and fully tighten Wood Screws (F).