Ballard Designs Villandry MN041 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 7-8-2020 Page 1 of 3
PRODUCT NAME: Villandry Dresser
ITEM NUMBER: MN041
ASSEMBLED DIMENSIONS : 36”H x 68”W x 20”D
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN INDONESIA

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 2 of 3
Ltr.
A 2
B
Qty. Hardware Included
Ltr.
1
Qty. Components
REQUIRED TOOLS:
Phillips Screwdriver
-Two person installation suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
Wall Anchoring
(Anti-tip) Kits
See Page 3
Dresser (B)
LEVELERS: Dresser is equipped with Rotary Levelers installed under each Leg. If necessary, Dresser
may be adjusted by carefully lifting applicable corner and turning Leveler clockwise/counterclockwise.
Cleaning and Care
DO NOT use alcohol based products or spray polishers
as finish damage may result.
Periodically dust with a soft, dry cloth.
WARNING
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
ANCHORING HARDWARE INCLUDED
Assemble in location for intended use.

(A)
(D)
(B)
(C)
W
A
LLS
T
U
D
WALL BRACKET MUST BE ATTACHED TO WALL STUD
WALL ANCHORING HARDWARE (ANTI-TIP)
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
Ltr.
A4 Small Screw
Retention Belt
Qty. Hardware Included
B4 Large Screw
C4 Bracket
D2
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screws (A).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screws (B) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
R
e
presen
t
a
tiv
e
Fu
r
nitu
r
e
I
tem
Page 3 of 3
Customer Service: 800-367-2810
Online: www.ballarddesigns.com