Ballard Designs Salerno MA275 User manual

PRODUCT NAME: Salerno Glass Door Cabinet
ITEM NUMBER: MA275
DIMENSIONS OF ITEM ASSEMBLED: 85”H X 49 1/2”W X 19”D
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 11-2-2020 Page 1 of 4
MADE IN CHINA
Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 4
Shelves (D)
Shelves (D)
Shelf Supports
Ltr.
B4
Qty. Hardware Included
A12
Ltr.
D3
Qty. Components
Hardware Located
Here (A-C)
C 2
Wood Plugs
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Wall Anchoring
Anti-tip Hardware
See Page 4
REQUIRED TOOLS:
Phillips and Flathead Screwdrivers
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
ANCHORING HARDWARE INCLUDED
Cleaning and Care
Periodically dust with a soft, dry cloth.
Prevent finish damage: do not use alchohol based
cleaners or polishers.
Assemble in location for intended use.

Page 3 of 4
(D)
(A)
(B)
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Assemble in location for intended use.
STEP 1: Determine location for each Shelf (D) then insert Shelf Supports (A) into corresponding
pre-drilled holes. Lay Shelf level upon Supports.
LEVELERS: Cabinet is equipped with Rotary Levelers under each corner, accessible from INSIDE
Cabinet. Insert Flathead Screwdriver (not included) into opening and turn Leveler clockwise/counter-
clockwise to adjust. When complete, cover each opening with Wood Plug (B).

Page 4 of 4
Wall
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
WALL BRACKET MUST BE ATTACHED TO WALL STUD
Installation:
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
WALL ANCHORING HARDWARE (ANTI-TIP)
(A)
(B)
(C)
(D)
(C)
Wall