Ballard Designs MO536 User manual

PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 2-23-2021 Page 1 of 5
PRODUCT NAME: Original Home Office Corner Desk Addition Zinc Work Surface*
ITEM NUMBER: MO536
ASSEMBLED DIMENSIONS : 28”H x 53 3/4”W x 33”D
IMPORTED
TM
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
*Corner Desk Addition Work Surface is designed for use with other Original Home Office Cabinets
and Work Surface Tops. Sold separately. Not designed as a stand alone work surface.

Page 2 of 5
Ltr.
A 24
B16
Qty. Hardware Included
Ltr.
D
E
1
1
Qty. Components
C
4
TOOLS REQUIRED:
Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
D
4
Wood Screw
Coarse Wood Screw
L-Bracket
Connector
Top
Leg
Assemble in location for intended use.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 3 of 5
STEP 1: Remove components and hardware from packaging.
Secure L-Brackets (C) to Leg (F) using Coarse Wood Screws (B). Firmly tighten.
STEP 2:
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 4 of 5
STEP 3: Invert Top (E) onto a clean, level, padded surface. Secure L-Brackets (C) on Leg (F)
to Top (E) using Coarse Wood Screws (B).
Attach Connectors (D) to underside end of each *Original Home Office Work Surface Top
using Wood Screws (A). Align Brackets over pre-drilled holes. Firmly tighten.
*NOTE: Original Home Office Work Surface Tops sold separately.
STEP 4:
Underside
Underside
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 5 of 5
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Attach Connectors (D) to underside end of each Original Home Office Top using
Wood Screws (A). Align Brackets over pre-dilled holes. Firmly tighten.
STEP 5 :
Cleaning and Care
Do not use chemical cleaners or polishers on zinc surface.
Protect by periodically polishing with a beeswax product.
If deeply scratched the protective coating could be compromised creating a
natural darkened or rusty patina.