Ballard Designs Casa Florentina SF017 User manual

PRODUCT NAME: Extended Antoinette Sideboard
ITEM NUMBER: SF017
ASSEMBLED DIMENSIONS: 36 1/2”H x 73 3/4”W x 17 1/4”D
PRODUCT NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 3-10-2020
MADE IN ITALY
Page 1 of 4
Customer Service : 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Ltr.
A 3
B 2
Qty. Hardware Included
Ltr.
D
E
5
2
Qty. Components
C 1
TOOLS NEEDED:
Phillips Screwdriver
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
NOTE: To avoid accidentally
discarding small parts or hardware,
retain all carton contents until
assembly and installation are complete.
Assemble in location for intended use.
Keys
Wall Anchoring
(Anti-tip) Kits
See page 4
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
ANCHORING HARDWARE INCLUDED
Sideboard (C)
Feet (D)
Shelves (E)
NOTE: Left Locks Decorative/Right Locks Operational

Customer Service: 800-367-2810
Online: www.ballarddesigns.com Page 3 of 4
STEP 1: Carefully place Console (C) back down onto a clean, padded, level surface then insert and
tighten Feet (D) into T-nuts embedded on underside.
NOTE: To prevent damage, do not place uneven pressure on Feet as Console is turned upright.
(D)
(C)
(E)
STEP 2: Place Shelves (E) onto fixed supports inside Console (C). NOTE: Shelves are not adjustable.
(C)

Page 4 of 4
Cleaning & Care
Do not use alcohol based products or spray polisher as finish damage may result.
Periodically dust with a soft, dry cloth.
Installation:
Ltr.
A2
Small Screw
Retention Belt
Qty. Hardware Included
B2
Large Screw
C4 Bracket
D2
WALL ANCHORING HARDWARE (ANTI-TIP)
1. Place furniture against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) to back of unit using Small Screw (B).
3. To keep hardware out of view after installation, attach remaining Bracket (C) INTO WALL STUD
with Large Screw (A) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
W
A
L
L
S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
(A)
(B)
(C)
(D)
R
e
presen
t
a
tiv
e
Fu
r
nitu
r
e
I
tem