B&G H5000 Pilot Use and care manual

Calibrating HLA analogue output on H5000
Connect HLA analog voltage output to a free analog channel in H5000 CPU;
Connect over Ethernet to H5000 CPU Websocket –(default is http//:192.168.0.2)
1. Go to System > Device list and select the appropriate channel –“H5000 Analog Channel x”
2. With HLA cal switch off and no load (V out = 0V) observe and record the value shown in the
drop down page. It should read 0.00 if HLA has been zeroed correctly;

3. Turn Cal switch on and record new value. Again this should read the Cal equivalent voltage if
the HLA has been correctly set up.

4. Click on “Configure” button at the bottom left of the dropdown box.
5. In “Analogue type”dropdown box select appropriate type, e.g. “Forestay”
6. Fill in table; Analog value 1 - 0.00
Analog value 2 - “Cal Equivalent Load” (e.g 2.88 Tonnes)
Analog Voltage 1 - Recorded “zero” voltage from step 2.
Analog Voltage 2 - Recorded “Cal” voltage from step 3.
7. Click on “Apply Values”
8. With Cal switch still on confirm that H5000 displays now read a “Forestay” value of the Cal
equivalent load (in this example 2.88T)
9. Turn off Cal switch. System is now set up
N.B. If the web page is accessible when tuning the HLA analogue output, steps 1. and 2. can be used
to adjust zero and span pots on the HLA as these values are simply reading voltage “V Out” from the
HLA .