BDI CENTRO 6402 User manual

Product Registration
Registering your new BDI product allows us to send you
important product updates, service information and helpful
hints related to your BDI products. Register today and you will
be entered to win free a BINK table from BDI. www.bdiusa.
com/product-registration/
Placement and Maintenance
Centro™Office furniture is designed for indoor use on level
floors. Clean glass with glass cleaner, and steel parts and
wood veneer with a moist cloth.
Your Centro™Office furniture is engineered for easy assembly.
Carefully follow this procedure to prevent any damage.
Do not use power tools for assembly of this product.
Step 1
Unpack and identify the parts listed below. The assembly
workspace should be a non-marring surface such as carpet.
For missing hardware pieces, please contact BDI Customer
Service at [email protected]. For all other
concerns, please contact your BDI retailer.
T1 4mm Hex Wrench
C1 - Glass Panel x 1
C3 -Leg x 1
C2 - Frame Assembly x 1
H19 Leveler Glide x 2
H6 1/4-20 x 12 mm Screw x 2
H7 1/4-20 x 38 mm Screw x 4
H8 1/4-20 x 61 mm Screw x 4
bdiusa.com
customerservic[email protected]om
CENTROTM 6402
RETURN
Designed by Matthew Weatherly.
These distinctive product configurations are protected by US and international patents, trade dress, and/or
copyright laws. Centro & BDI are trademarks of Becker Designed, Inc. All rights reserved. ©2015, BDI
Made in Taiwan. 01.08.2016 V1
H11 Cord Wrap x 3
H12 - Snap Fastener x 3
H13 Bumper x 2

bdiusa.com
customerservic[email protected]om
CENTRO 6402
RETURN
2
Step 1 - Install Glides H10 to the bottom of Leg C3. Attach Leg C3 to Frame Assembly C2 with Screws H7.
H10 (x2)
H7 (x4)
Step 2 - Install BDI Cord Wraps H11 using Snap Fasteners H12 into hole locations as shown. Install
Bumpers H13 into holes as shown.
H11 (x3)
C3
H12 (x3)
H13 (x2)
H13
H13

bdiusa.com
customerservic[email protected]om
CENTRO 6402
RETURN
3
Step 3 - Remove glass top from the Centro Desk. Position the Frame Assembly C2 at the desired end of the
Centro Desk. Attach the return to the desk with Screws H6 using Hex Wrench. Carefully place Glass Panel
C1 on top of return.
Step 4 - Secure Glass Panel C1 to Frame Assembly C2 using Screws H8 and Hex Wrench. Do not over
tighten.
Centro 6401 Desk
(with glass removed)
H6 (x2)
H8 (x4)