DCN Wireless | Quick Reference Card | DCN-WD Wireless Discussion Unit (Single Delegate)
Bosch Security Systems | 2006-08 | 9922 141 91301 en © Bosch Security Systems B.V. | Data subject to change without notice
en
Microphone
To activate the microphone:
Push the microphone button to activate the microphone
of your wireless discussion unit.
• If the red light around the microphone button comes
on, you can speak.
• If the green light around the microphone button
comes on, your request-to-speak is accepted. You
cannot speak until the red light around the
microphone button comes on.
To cancel a request-to-speak:
When the green light around the microphone button is
on, push the microphone button to cancel the
request-to-speak. The operator can disable the
possibility to cancel the request-to-speak.
To deactivate the microphone:
When the red light around the microphone button is on,
push the microphone button to deactivate the
microphone. The red light around the microphone
button goes off. The operator can deactivate the
possibility to disable the microphone.
To make a request-to-respond:
When the operator enables the response function, you
can make a request-to-respond to speak to the current
speaker. Push voting button 3to make a
request-to-respond. The yellow light around voting
button 3flashes. You cannot speak until the operator
accepts your request-to-respond. When the operator
accepts your request-to-respond, the red light around
the microphone button comes on.
To cancel a request-to-respond:
When the yellow light around voting button 3flashes,
push voting button 3to cancel the request-to-respond.
The operator can disable the possibility to cancel the
request-to-respond.
Push-to-talk mode
When your wireless discussion unit is in the PTT (push-
to-talk) mode, the microphone is activated as long as
you push the microphone button.
Auxiliary control
Your wireless discussion unit can have two microphone
buttons (refer to the figure below).
When your wireless discussion unit has two microphone
buttons, the left microphone button is an auxiliary
control.
Voting
Standard procedure:
1 The operator starts the voting session. When the
voting session is started, the yellow light adjacent to
voting button 1flashes.
2 Push voting button 1to confirm that you are present.
The yellow lights around the available voting buttons
flash.
3 Cast your vote. You can change your vote until the
operator stops the voting session.
Note
Some types of wireless discussion units do not
have voting buttons. With these types of
wireless discussion units, you cannot make a
request-to-respond.
Note
Some types of wireless discussion units do not
have voting buttons. With these types of
wireless discussion units, you cannot cast
votes.
