BROSA Rochefort Vintage Dining Table User manual

ASSEMBLY GUIDE
Rochefort Vintage Dining Table
v1.0

Components
Upon unpacking your dining table from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your dining table.
Table top x 1
Leg x 4
Hardware
What you need
1
2
2
2
2
A x 4
(Ø12 x 80/Ø8) (Ø8 x Ø19 x 1.2) (Ø8 x Ø13 x 1.8) (M8) (M8 x 100) (M8 x 88 x 2)
B x 8 C x 8 D x 8 E x 8 F x 1

Step 1 Insert a cross dowel (A) into the hole at the top of
the leg (2), making sure that the threaded sockets in
the dowel is aligned with the holes on the inner face
of the leg.
Step 2 Insert a threaded rod (E) into the hole on the inner
face of the leg (2), screwing it tightly in place. Repeat
for another hole and then repeat for the remaining
legs.
A
A x 4
E x 8
E
2

Step 3 Align a leg to the underside of the table top (1),
making sure the threaded rods protruding from the
leg t into the holes in the frame. Fit a at washer
(B) to the rod followed by a spring washer (C) and
then a hex nut (D). Use the spanner (F) to tighten
the nut in place. Repeat for the remaining legs.
Step 4 Gently lift the table and place it upright on a level
surface. Enjoy your new dining table!
B x 8
C x 8
D x 8
F x 1
B
C
D
F
1